How to fix a plumbing leak?

[Phillbo]

Is that a trap ? If so , can you cut it out and install a smaller one? Or just a straight piece of PVC?

[JohnASmith]

Not a trap. What you are looking at is a mixer assembly with pressure air from one 2" line and water from another 2" line. The other side of that assembly goes thru the pool wall. It can't be touched without causing severe damage. I have managed to stop the leak with a temporary fix. I wrapped the affected area with a 1/2" rubber tape I found in the plumbing dept at Lowes and put a couple of hose clamps on it. We used the pool yesterday and not a drop of water leaked. When I find a similar, but wider, rubber tape I will redo it and call it good.

[TheGoose]

What does that flex pvc go to?

[JohnASmith]

What does that flex pvc go to?

There are 18 mixer/jet assemblies in the pool fed by a 2 HP water pump and an air blower.

[JohnASmith]

I think my latest effort will be a permanent repair. I located a heavy 2" wide rubber tape that is actually made for insulating and waterproofing electrical splices and is made by 3M. It is very similar to the 1" rubber tape I had already installed but didn't have 100% confidence in because it only lapped a 1/2" each side of the leak. I left the 1" in place since it has worked fine for a couple of weeks and put the heavier 2" on top of it. I was able to stretch it to a very tight wrap. After putting the hose clamps back in place it is likely stronger now than the pipe it repairs. Next I will reinstall the jets and run the air blower to check everything under pressure. After passing that final test I will wrap the hose clamps and fill the hole.