how to lower water level using pool pump

[CarlD]

Hi John!

Has the water in the pool risen again or did it stay down?

Carl

[johninmartinez]

I just took a look. It's been 48 hours since I lowered it. I would say the level has stayed the same. The spillover between my spa and pool is a bit wet but that's probably because we've had very high winds the last 24 hours or so. The water level is still just below the spillover, which is where I set it. If it starts creeping up, any guesses as to the cause?

[CarlD]

I guess it comes down to:
1) Rain
2) Spillover
3) something leaking between them
4) something else leaking into the pool

I don't see any other possibilities. 3) and 4) would probably imply a valve or cut-off leaking.

Carl

[johninmartinez]

OK, thanks Carl. Since it hasn't rained here in six weeks, I'll focus on 2) through 4). I will keep a close watch on it from here on. If it keeps recurring, sounds like I'll have to do some leak detection (i.e., digging). Thanks for the suggestions.

- John

[bobodaclown]

I added a draing to my Clean and Clear filter, its easy, Maybe 30 in parts. Cheaper and easier than a sump pump.
http://www.troublefreepool.com/addin...ng-t35088.html

[johninmartinez]

thanks for passing that thread along. If I feel adventurous, I may give it a try.