Question about the salt test in the PS234s

[Tcap]

The salt test from the PS234 has to be the one you use to calibrate the Aqualogic's setting. Once you drain down and refill, check with the PS234 again, and if you have less than 4000 ppm, set the Aqualogic to the salt test value you got.

The Aqualogic is set to a default reading until checked against a salt test, and then you adjust the Aqualogic accordingly.

Hope this helps.

Pat

Hi Pat,

Thanks for the response. How do I set the Aqualogic to the salt test value? None of my manuals have anything on how to do that. I checked on-line to see if those manuals did - maybe an updated version or something and they don't mention it either. It did read higher at one point and came down after the initial drain so I think it is reading. Before we added salt last Sept. it did read that it had low salt and then was in range for the couple of weeks we had it open in Sept.

Thanks,
Tracy