Today I woke up to my Jandy PDA telling me to "Check Aqua pure", "General Fault", and my salt level reading is about 500 PPM lower than it was yesterday. After googling the problem to see what to do, the general steps to do is to find the 3 digit error code and troubleshoot from there. I am not sure how to attain this code! My system Consists of a Aqua link RS power center, and the Jandy PDA. I do not have a separate box to control the SWCG, i control everything with the PDA.

I have tried to go through the PDA and see if there is a menu to read the code but could not find anything. Is there something i am missing? How do i find out the 3 digit code?

Thanks,
Jeremy