Question: How to run a Variable Speed Pump from an Autopilot Digital SWG Controller.

Somewhere I read an answer on how to do this, but I can't remember the specifics.

I have an Autopilot Digital SWG System and just installed a VS 3050 Pentair pump (Model 011018).

The artical I read said the Autopilot will keep the low speed circuit energized 100% of the time, except when the High Speed circuit is on, and to re-wire the Autopilot for Two-Speed Mode and connect the VS-3050 to the Low Speed circuit, which I did.

My problem is; how do I now control the SW Cell?

If I try to program the Autopilot, it only asks when to turn on the high speed circuit.
If I use the High Speed mode, it shuts off the power to the VS 3050.


Thanks,
Steve