Replacing liner with high water table

[jjdean]

Thanks Waste.

I think I understand what you're saying: Wait until the water gets near the bottom faceplate of the stairs, then raise the vacuum lines up a bit, and if I've sealed the liner good enough - the liner should pull into the area where the stairs extend out from the wall (hopefully the liner will stretch enough to be flush against the wall at the bottom corners of the stairs). I suppose I could heat the liner with a hair dryer if I have to, and manually force the corners in?

Jeff

[waste]

Sounds like we're on the same page

I would avoid heating the liner to get the faceplates on - with a 70*+ day and sun, the liner should be pliable enough to get the faceplates on. If you need a little more stretch, you can cut the center of the liner that you'll be removing from the steps (in other words, stretch it from the stair side NOT from the corners). Definitely have the bottom plate installed first!

Please let me know if you have more questions about this!