Hi I would just like to say that this is a great site and I have already learned alot. So I have a new pool that I am getting filled tomorrow. Because of my poor planning I wont have the taylor test kit for another few days. I have decided to use the BBB method. I have no doubt it will work great, and it better cuz I got into a small fight with my wife about doing it this way. Anyways, my questions are these....Is there any way to give me a ball park figure on how much of everything to put in before I actually test the water?? or is it better to wait till the kit arrives and I can test the water before I add anything? It is a 24' round pool. I am having it filled mostly by the water man. I have bleach, baking soda, borax, and cyanuric acid all ready to go. (FYI I found the CYA at my local walmart, but that was after I went to the dreaded pool store to get it)I used my well water to put 2" in the bottom to set the liner, which brings me to my next queston. I have a good amount of iron in the water. To the point that I can see it all over the bottom. Will this be bad for the liner or anything? and will I be able to just vacuum it out? Thanks in advance, Andy