Cloudy pool/white stringy(snotty) stuff?

[CarlD]

Watermom is correct, but I didn't want to overwhelm you just yet. Still the $50-$70 you spend on the K-2006 will be the best investment you make in your pool. We all use either that or an equivalent kit. Still, when things settle down you'll use the little yellow and red kit for your daily testing and the full kit once a week.

Ultimately, it will all come down to 3 things:

How much chlorine you put it, using mostly just bleach. This is to keep the water sanitary.

What the pH is and how to adjust it. This is to keep the water from being to acid or alkaline and irritating skin and eyes, or even damaging the pool.

How much stabilizer you have, which acts like sunscreen for chlorine, but also slows the chlorine's effectiveness down. The level of stabilizer determines the level of chlorine you need.

That's it. That's ALL pool maintenance comes down to. Sanitation and pH--and things that affect that.

Carl

[starfish]

Okay, I put the bleach in last night. I went this morning to Home Depot and got the dropper test.

I read the charts on there, and it is saying I need to put alot more ph minus in it than I was doing.
I was going by the test strips and only putting 6 dry ounces in at a time. This says I need around 9 cups! Wow! I have not put the new dosage of ph minus in it yet.
The water does look clearer today. The white stuff was just in the beginning stages this time, so it looks like the bleach might have knocked it out.
So, will I stiil be able to use the chlorine tabs I got? They cost alot and I really don't want to waste them.
So, what do I need to next to my water?....thank you so much for the information!!!!! )

I did the dropper test this morning.
Readings were:
Chlorine:3.0 to 5.0
ph: 8.2
alk: 360
Now I just went and checked it and it says almost no chlorine.
My pool holds 2,150 gallons.
I know now I need to put alot more ph minus in then I was using.
How much stabilizer should I put in and how often?
How much bleach per day, and can I still use my chlorine tabs?
The test says I need to put 9 cups of phminus in.
What order to do these, and best time of day?
Thank you so much! )

[aylad]

The reason you have almost no chlorine is that you don't yet have stabilizer in the water to keep the sun from consuming it. So..until you have enough stabilizer registering (which is going to take a couple of days), you'll need to add bleach 2-3 times a day to make sure you always have at least 3 ppm of chlorine in the pool. In your pool, if you'll take 6 oz of stabilizer and put it in an old sock and tie it in front of a return, it will dissolve slowly over a couple of days. You can give the sock a squeeze a couple of times a day to help it dissolve faster . This should target your pool for about 20 ppm. You really want to get it up to about 40 ppm, but if you want to use the trichlor tabs, they also increase CYA, just not fast enough for an initial dose. So...use the 6 oz to get "some" in the water, then you can use your tabs until it gets up to 40 or 50 ppm. Your pH will probably fall a little due to the CYA addition, but will definitely fall due to the trichlor tabs, so keep an eye on it. For right now, I would go ahead and lower the pH a little, but not lower than 7.6 or so. I would start with a couple of cups at a time, not 9 cups all at once. Add it slowly through the skimmer, breaking up any clumps, give it a couple of hours to recirculate, then test and add more as needed.

Take a look at your trichlor tabs, and make sure they're not labeled "dual actions" or have copper listed in the ingredient list. If so, then take them back if you can, because you don't want to use anything that contains copper in your pool. If they are copper free, then you can use them in a floater--just make sure the floater doesn't float to the edge of the pool and sit there, because concentrated pockets of chlorine and low pH can fade your vinyl.

So...go ahead and add your bleach, then add your pH minus, then hang your CYA sock. If you have non-copper containing tabs and a floater, then you can go ahead and add those too. But for the time being, check your chlorine at least 2-3 times a day and add bleach if needed to keep your chlorine between 3-6 ppm at all times.

[starfish]

Thankyou sooo much Janet! I will be doing all this this evening! )