Pool walls out of square

[Figstimpy]

I am pretty sure they never put a tape to it at all by the way it measures, think they just bolted the panels together that were suppose together and didnt check anything else.

I haven't checked the depths as i am not sure what size of coping will be on the top of the walls

When we were planning the pool they would get back to me via email within an hour of sending it... its been 2 days since i sent them saying no to there $1000 deal and the costs i figure it would cost them to take it out. Feels a liitle like there avoiding the situation

Thanks again for your insight

[Manslick]

Feels a liitle like there avoiding the situation

Well could be, though it is the busy time of year. All you really can do is try to reason with them and work out a solution. No one wants a court battle.

You can check the walls against the floor with a framing square. Should be pretty easy to see.

I have never tried Angie's List myself but you might find something there.

Best of luck.

[waste]

Sorry you're having this issue! With a little care the collar can be removed without damaging the panels - I've done it a few times. There is no doubt that you got a substandard install. Your estimate of the cost to fix it is probably a little low and they are offering you ~10% of that to 'deal with' their mistake. Squaring a liner pool is a little tedious, but not difficult because once you establish one wall, it's pretty easy to get the rest of the pool 'squared' up with it.

I've built over 500 IG liner pools and am willing to discuss this with you more. I HOPE you get decent resolution on this!

[Figstimpy]

They got back to me, they want to meet up to talk... he said and I quote "theres no way I am gibving you F****** $10,000" I said i wasnt asking for it just saying what it would cost to take it out and redo it, and that the $1000 was a joke.

My question is will the out of square cause any issues down the road such as liner not fitting properly or is it purely going to be cosmetic and just be something I have to get use to looking at every day?

Thanks again guys for all your feedback

[Manslick]

They got back to me, they want to meet up to talk... he said and I quote "theres no way I am gibving you F****** $10,000" I said i wasnt asking for it just saying what it would cost to take it out and redo it, and that the $1000 was a joke.

My question is will the out of square cause any issues down the road such as liner not fitting properly or is it purely going to be cosmetic and just be something I have to get use to looking at every day?
Thanks again guys for all your feedback

You will most likely have wrinkles in those tight corners <90 degrees and stretching in the ones >90 degrees. Maybe even liner coming out of the coping.

Check how bad the out of square angles are by using a framing square. One of the building experts here may be able to predict the issues.

[Figstimpy]

None of the corners are 90's there 2' round corners so I can't check with a framing square. Do u think the same liner issues will be with the round one as there would of been with the square corners

[Manslick]

It’s hard to predict. I’d guess the round corners to be more forgiving than tight square corners. I only have experience with my pool with square corners.
Even with radius corners you have the angle between adjacent walls.

Maybe waste will drop in for a visit.