+ Reply to Thread
Results 1 to 10 of 12

Thread: Need some advice

Hybrid View

  1. #1
    Join Date
    May 2010
    Location
    322 Church St
    Posts
    33

    Default Re: Need some advice

    That's the filter/pump that I have. You can use that as the filter and pump. It takes a type "B" filter. Like I said, you will have to clean that paper filter pretty regularly, but it will do the job just fine. It just requires a bit more work than the sand filter. I removed the filter cartridge and hooked into a sand filter and just use it as a pump. Some sand filters come with a pump built onto the unit, but I'm not sure what you have.

  2. #2
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

    Default Re: Need some advice

    Thanks, Mwil3. Like I said in my post above, I am not too up on the Intex products. Thanks for chiming in here to help this poster.

  3. #3
    Join Date
    Jun 2011
    Posts
    6

    Default Re: Need some advice

    The kits for testing water by Amato Industries isn't on amazon. Is their another seller that would be ok to buy from?

  4. #4
    CarlD's Avatar
    CarlD is offline SuperMod Emeritus Vortex Adjuster CarlD 4 stars CarlD 4 stars CarlD 4 stars CarlD 4 stars CarlD 4 stars CarlD 4 stars
    Join Date
    Dec 1969
    Location
    North Central NJ
    Posts
    6,607

    Default Re: Need some advice

    You can always buy it directly from Taylortechnologies.com, but at MSRP.

    Not sure how you attach the sand filter to the Intex pump. Their web site isn't showing the sand filter.

    Here's the big question: Do you have a level surface? If you don't you'll spend more time and effort on that than you will on the setting the pool up. It's the one thing Intex doesn't tell you. But don't blame them: Nobody else does.

    I was probably the first person on PoolForum with an Intex Donut, 15x3, and we used it from 2000 to 2002. It was GREAT! and I learned so much that when I put in a nearly 20,000 gallon FantaSea, I knew pretty much exactly what to do.

    Good luck!

    Carl
    Carl

  5. #5
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

    Default Re: Need some advice

    sherron,
    Give it a day or two. There have been quite a few times this season where the Amazon link didn't show Amato Industries as the seller for a day or two. I assume it was when they sold out but each time, within a day or so, they were once again listed as the seller. Hopefully that is what has happened this time as well and they will restock quickly.

  6. #6
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

    Default Re: Need some advice

    Sherron,
    I just checked and the Amazon links below now list Amato Industries as the seller again for the 2006 and the 2006C. I think they sell and out then get more. This is the 3rd or 4th time I have seen this happen but fortunately, it is usually pretty quick for them to be back again with more kits.

  7. #7
    Join Date
    Jun 2011
    Posts
    6

    Default Re: Need some advice

    Thanks Watermom. Just ordered.

+ Reply to Thread

Similar Threads

  1. need advice on what do to first
    By sherraechas in forum Using Chlorine and Chlorinating Chemicals
    Replies: 6
    Last Post: 06-26-2012, 01:44 PM
  2. Hot tub advice
    By myatinsel in forum General Interest
    Replies: 1
    Last Post: 10-19-2011, 02:02 PM
  3. Hello All need some advice.
    By 55fordtruck in forum Dealing with Algae & Slime
    Replies: 4
    Last Post: 08-19-2011, 09:28 PM
  4. 18' AG Advice
    By cramar in forum Above-Ground Pool Construction & Repair
    Replies: 4
    Last Post: 11-19-2010, 02:05 PM
  5. Advice please.
    By savdoc2 in forum Pool Startup, Shutdown, & Winter Operation
    Replies: 4
    Last Post: 04-25-2006, 06:58 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts