For reasons too complicated to explain here, I would like to reconfigure a Jandy 3 way valve so it will completely stop the flow of water to two different jets in the pool.

Currently, the valve is set up to direct the flow of water to one of two different jets. If I position the valve between the ports a portion of the flow will be directed to both sets of jets. I would like to stop the flow of water to both sets of jets at the same time.

The valve is currently positioned so the flow enters the center port and is distributed to one or both of the two remaining ports.

Am I correct in believing if I reposition the top of the valve in the housing 180 degrees from it's current position, I can stop the flow of water completly to both sets of jets by blocking the input port?

Any and all comments are welcome. Bill