Pump recommendations for 24' semi-inground pool

[CarlD]

It all comes down to flow rates. I have an "IG" pump and filter for an "AG" pool with no problem. It's sized correctly. So I have a 1hp Hayward Superpump 2 speed with a Hayward 200# sand filter (I think it's rated as 21", it's the T-210) and it's a perfect fit. In theory, I perhaps should have gotten a 250# or 300# filter, but the 200# is adequate, and at low speed superb. You may want to consider a combo, where the manufacturer has matched pump and filter on a single base. It's generally a safe enough combo. I actually called Hayward to check that the t-210 was adequate for the Superpump.

There's more to it than that if you really want to get into feet of head and flow rates.

Carl

[mas985]

No argument there. It was just that the OP posted the following specs for the current filter which is why I suggested a new filter if he goes with a SuperPump. It will well exceed the flow rate requirements of the filter and not a good match.

The label on the pump motor says Sta-rite JWPA5FL-2A2, 1.5HP 115V VD 3FT20A
It really just mentions power usage, not flow.
The label on the tank says model PLM100
Max work pressure: 50PSI
FIlter area: 100 sq ft
Max flow rate: 37GPM

However, I believe that most if not all pump/filter combo units are for AG pools and I think would end up with the same problem.

[EricD]

Thank you all. The friendly salesman said that my filter would not be a good match for an IG pump for the reasons outlined by Mark. So I would have to buy a new pump and filter.

If I knew what I learned here last year, I would have opted for a small IG pump/filter combo as the price difference would have been relatively small. But now, even if I could sell my AG pump/filter used, it's a more expensive upgrade. I'll try to work with the equipment I have for now.

Carl, I used Cartridge Renu, purchased at the pool store. But I will try Electric dishwasher detergent next time. I'll also look for skimmer socks.

Eric

[EricD]

Quick update: I ran the pump without the cartridge and with a pollen cloth in the skimmer basket for 2 days while the cartridge soaked in cleaning solution. Within a few hours, I collected enough pollen to make a nice yellow "snowball". No wonder the filter clogged so fast! I put the cartridge back in and it's been running beautifully.

I want to thank everyone for spending the time to help me with this issue.

Eric