additional.
when i got home i pulled off a cap to expose the bead and track.
i tried pulling the liner (luckily it has been over 30 degrees Celcius today) up to tuck the bead into the channel but it wouldn't seem to stay.
does anyone have any tricks to get the bead to stay in the groove as i work my way down the edge? Is there supposed to be a plastic strip or something that goes in to hold the liner?
also, there seems to be a lot of air behind the liner especially in the corners (lots of corners) ... is this something i need to be concerned about?
should i raise the water level first before fixing the liner in the hopes that the water pressure will force out the air?
any tricks or suggestions would be helpful
Shot at 2011-05-31
Shot at 2011-05-31
Bookmarks