Pump and filter sizing

[wsommariva]

Hi everyone,

Just want to make sure that I have adequate sized equipment.

10,000 gal fiberglass. 1.5 hp pump and 36 sq ft PE filter.

Thanks

[Watermom]

Pump is WAY too big for your pool.

[wsommariva]

Thank you. Just a waste of electricity or could it cause problems.

[wsommariva]

BTW I have a heat pump also if that matters.

[madwil]

the heat pump doesn't affect your pump, much- might slightly lower your water flow, which is probably a good thing in your case.
The pump and filter matchup is the concern- if you overdrive the filter, it won't work as well and you could get to much pressure and damage the filter if it gets to extreme.

[wsommariva]

Thank you. I'm considering buying a new filter. 48 sq ft DE. I have a Pentair 36 now, upgrade to a Pentair 48. I've always had cloudyness problems.

Is this a sound decision?

[wsommariva]

Alternatively, maybe buy a 1 hp pump instead of a new filter? Pumps are cheaper and perhaps more likely to fail being the reasons.

Is 36 sq ft of DE (my current filter) adequate for a 10,000 gal in ground?

[Watermom]

i can't advise you on the DE filter but I will tell you that for a 10K pool, you don't need a 1 hp pump. I have approx. 13K and I have a 1/2 hp full-rated inground pump on my AG pool and a 200 lb. sand filter and that pump is plenty big for my pool.

[wsommariva]

I'm checking with Pentair to see if they think my filtering capabilities are significantly decreased with my 1.5 pump. If so I will replace.

Thanks again everyone for your assistance.

[Watermom]

But, just remember, Pentair is in the business to sell pumps and make lots of money. Bigger pumps equal more money in their pocket. I'm just sayin ..................