RayPak and Intellitouch i5

[dchango]

I have an Intellitouch i5 control system. I am trying to connect my RayPak R6350ti-E-HC to the intellitouch, but the manual does not really tell you how. The heat pump has a two wire and three wire remote hook up, I’m not sure where one would attach it to the controller. I contacted Pentair all they would say it is compatible. Any help would be appreciated.

Damon

[aylad]

Bump.....anybody know how to help this poster?

Janet

[Pool Clown]

http://www.raypak.com/uploads/RP6000.552C.pdf

Page 27 hook up at the heater end.

Calling Raypak may get you a little farther than Pentair for hookup at the Pentair end (go figure).

[dchango]

Thanks for the info, I have the owners that shows the wire configuration for the RayPak. I did take your advice and contacted RayPak about the hookup, and also sent another email to Pentair. Now its wait and see.

Damon