Nothing like the smell of a freshly opened can of Spam.
Nothing like the smell of a freshly opened can of Spam.
IG 32' x 16', vinyl 19,500 l, Sand filter, Hawyard Low NOx 250,000 btu heater
Heating? Great info on why a solar cover saves $$$?
http://energy.gov/energysaver/articl...ng-pool-covers
As noted in that thread on the other forum you are referring to, his arguments to the points waterbear made are ridiculous. He is in Canada so the EPA registration doesn't apply -- but what does that have to do with efficacy of copper sulfate? It doesn't pass EPA DIS/TSS-12 in the U.S. and I write more about kill times in this post and I write more about sanitizer and disinfectant registration in Canada below.
He claims it is not slow-acting because copper sulfate is not the only ingredient in this powdered chemical. I cannot find "Seapool" as a brand on the Internet -- if the guy can provide a link to where it is sold, I might be able to dig up an MSDS equivalent -- or he can just read the ingredients on the bottle. Disinfectants and sanitizers ARE regulated in Canada as described in this link. As seen here, Seapool is NOT a registered pesticide product though there are many other algaecide products registered using copper sulphate. There are also registered swimming pool bactericides such as products containing calcium hypochlorite (Cal-Hypo), sodium hypochlorite, trichloro-s-triazinetrione (Trichlor), sodium dichloro-s-triazinetrione (Dichlor). See if he can provide you with a Health Canada Pesticide Registration Number.
His response to point #3 is that "copper isn't just used as an algaecide, it is also used as a pH balancer" shows that he doesn't understand chemistry as that is absolutely not true. Copper does not balance pH, period.
In his response to point 4 he says that "in high concentrations copper can turn your hair green", but then says that "in Seapool it the ppm is an ammount close to 10-15 ppm" which would certainly stain since normal copper concentration in a pool to prevent algae is in the 0.3 to 0.7 range and anything higher is certainly going to stain unless the pH is kept very low (7.0 or lower).
Good luck with your arguing with this person.
Richard
To Quote Forest Gump, "Stupid is as stupid does."
Retired pool store and commercial pool maintenance guy.
LOL. Good digging Chemgeek. That is actually a very, very good high tech and electronics forum, and is terrific for over the air broadcast reception, with very knowledgable people on those topics similar to the pool know how here... but pool stuff not so much.
I couldn't find Poolsea on the net either. I'll keep your facts in the quiver in case he wants to pursue it further. Right now it is sinking out of site, as that is a high traffic site.
IG 32' x 16', vinyl 19,500 l, Sand filter, Hawyard Low NOx 250,000 btu heater
Heating? Great info on why a solar cover saves $$$?
http://energy.gov/energysaver/articl...ng-pool-covers
Ok, Here's the answer:
NOBODY swim in this fool's pool!
"For every complex problem there is an answer that is clear, simple, and wrong." -- H. L. Mencken
(this is one of my two favorite quotes.)
Carl
Your guy apparently has only heard about the product, and not read about it. It's "C-Pool", not "Seapool".
Here are the links:http://www.debmar.com/pool/faq.htmlThe treatment program is just a typical chlorine + copper program:
http://www.c-pool.ca/
from the c-pool.ca site:
* Add 3.5g (1/8 oz.) of C-POOL per 4,500 L (1,000 gal.) of pool water (an additional 0.03 ppm) to maintain a minimum reading of 0.5 ppm Copper. This amount will normally be sufficient, depending on water loss from backwashing the filter etc( http://www.c-pool.ca/howtouse.html )
* Check Copper reading. Use readily available test kits to ensure copper levels are maintained at 0.5 ppm to 1.0 ppm (do not exceed 1.0 pmm copper)
* Add chlorine to achieve an ideal reading of 1.5 ppm. IF using a Brominator or Chlorinator, fill and place on lowest setting
* Check and adjust pH to 7.2
Ben
right off their websites FAQ:
"Is the C-Pool Mineral Treatment safe?
Yes. C-Pool Mineral Treatment is registered by the Canadian Government as a Mineral Algaecide for pools and spas."
Empahsis mine! Not once do they claim it is a sanitizer.
This page is good for laughs. In one sentence they say the 'mineral' in c-pool ( is that short for copper pool or cesspool?) kills algae and in the next say they are essential for plant growth. Last time I checked algae was a plant.
Deja Vu, does anyone remember SimplyBluePools
Check out some of the other products that Debmar sells! Besides buckets of copper sulfate they also sell electromagnets for horses, dogs, and peopleand silicone breast enhancers (I think they call them 'falsies')
.
The only "pool product" they sell is c-pool. I think that says it all (along with the falsies!)
EDIT: Here is the original patent for c-pool.
As you can see it's just a mixture of copper sulfate, alum, soda ash, and salt. It's just an algaecide/floc combo.
This page from the patent shows a real lack of chemical understanding of the product, especially when it states near the top of the third page "Salt crystals can be added as a source of chlorine."
I find it interesting that this product is only sold in Canada and not the US (although we do have the similar EZ Pool and Pristine Blue "systems").
Last edited by waterbear; 07-25-2010 at 03:38 PM.
Retired pool store and commercial pool maintenance guy.
Bookmarks