I have asked Ben to take the time to read this entire thread if he hasn't yet done so.
Printable View
I have asked Ben to take the time to read this entire thread if he hasn't yet done so.
@Watermom, yes I remember (in-fact I read the entire thread this a.m.). Here's a thought; the first dose I used I put in a 5 gallon bucket for a few hours to dissolve. Maybe I thought more was dissolved than actually was and when I put it in my pump sucked out what wasn't dissolved. That said, when I did my second application using the sock I followed the directions on the back of the HTH container and added recommended amount to raise to my target level.
Just thinking out loud.
If you poured the water/CYA from the bucket into your skimmer, it would have finished dissolving in the filter and should still be able to be accounted for. Did you backwash any after you added it via the skimmer? If so, how long after the application?
I don't know what's going on. Complete the pool equip form, and the pool test form, and I'll take a look:
http://pool9.net/pf-equip-form
http://pool9.net/pf-hist-form
I believe he has and I'm running a test he requested now.Quote:
Originally Posted by Watermom
Sorry for the confusion. I don't have a skimmer. I dissolved the original application in about 3 gallons of warm water, stirring about every 15 minutes for 5 hours until most of it was dissolved (I thought). Then I dumped it in the pool and used a brush to spread around any granules that were on the bottom and I didn't run my pump for 24 hours to prevent the granules that were left from going into the filter. Sorry for any confusion.Quote:
Originally Posted by Watermom
Test ResultsQuote:
Originally Posted by PoolDoc
Prior to putting bleach in - 1
After putting bleach in and pump running 1 hour - 13
8 hours later - 3
Today's test results from pool store:
FAC - 1.5
TAC - 4.5
Salt - 3,000
CYA - 70 - It's coming-up!!!!!!
TA - 120
pH - 8
Acid - 2
Pho - 0
With your stated 5,061 gallons, 47ozs CYA gets you to 70 (from zero). You added more than that correct?
FC is to low and pH is to high. pH could be much higher as 8 is the max result from the basic test.
Yes, lowered pH to 7.5 overnight. Ran SWG overnight thinking it would bring chlorine up but it dropped overnight to about 1. I'm starting to think my SWG isn't functioning properly. Threw some bleach in this morning after I tested.Quote:
Originally Posted by Big Splash
That is a red flag. There is something in your pool causing high CC. This is what is using up your chlorine. It could be the same thing that is consuming your CYA as well. You need to shock the pool and keep it at shock levels until FC equals TC and FC holds overnight.Quote:
Originally Posted by QiingGuy