No FC but pool is crystal clear

Ironically, what can happen if you have ammonia from biodegraded CYA, is that you end up with monochloramine in your pool. This is the same algaecide that you're trying to produce when you use "Yellow Out", "Mustard Master" or similar products.

Monochloramine is a VERY good algaecide, better than plain chlorine. The problem is that it's a fairly good people-cide! It doesn't actually kill people, but it will run them out the pool with burning eyes and itching or red skin!

Fortunately, it breaks down pretty quickly as you add MORE chlorine, but during the brief periods when it's present, it can do a number on the algae.

Added another 3 gallons of bleach last night. This morning it is gone again.

FC=0
TAC=.5
Alk=90
ph=7.2
CYA=40

Question= bleach is getting expensive as it is up to 2.50 or so per gallon. is 63% calcium hypochloride as effective as 8.25% sodium hypochloride? Is 1 ilb bag equivalent to 1 gallon of 8.25% bleach?

Thanks

Check the available chlorine % --if that's 60% or higher, it's mostly undiluted cal hypo.

With a TA=90, you can probably use cal hypo OK -- but what is your calcium level? (How are you testing?)

To answer your question, a pound of cal hypo with 65% available chlorine is roughly equivalent to a gallon of 8% bleach, in chlorine added to your pool.

My Calcium levels are low at 160 so I am not concerned there. Does cal hypo raise or lower TA?

oh and until my taylor 2006 arrives I am using the walmart HTH 6in1

It raises both TA and CH. It is possible -- with a sand filter -- to use cal hypo so that, once the pH + CA + CH are at saturation, the rise stops.

You're not at that point yet. But if you add cal hypo via the skimmer AND let your pH float, it will stabilize near saturation. This is not a great idea if you have a heater, and MUST not be done if you have ANY sort of feeder or chemicals ANYWHERE between the skimmer and the filter: cal hypo tends to react VERY BADLY if it comes into direct contact with any number of other chemicals, including forms of chlorine.

I went to ocean state job lot. they have liquid mega shock 12.5% sod cl for 2.99 a gallon. Bought 2 cases. It is cheaper than bleach right now. I added 2 last night. Levels high. woke up and back to nothing again.

TAC=.5
FC=0

CYA=40
TA=100
PH=7.2
calcium=160

Quote:

---

Originally Posted by soupy01833

I went to ocean state job lot. they have liquid mega shock 12.5% sod cl for 2.99 a gallon. Bought 2 cases. It is cheaper than bleach right now. I added 2 last night. Levels high. woke up and back to nothing again.

TAC=.5
FC=0

CYA=40
TA=100
PH=7.2
calcium=160

---

Keep at it, you'll get there. ;)

Losing chlorine overnight actually means you are accomplishing something: breaking down whatever residue is present in your pool. (Daytime loss is often just to sunlight.)

well, this is the first morning I had both FC and TAC when I woke up. It was not much but at least it was around FC=3 and TAC=3. It is mostly gone now during the day. Do I need to keep going to shock level? or simply try to get it to stay at around 6-7?

My 2006 kit should be here this week sometime. Strips are all I have to measure FC at the moment.

You probably need to use dichlor long enough to get your stabilizer up. Dichlor adds 9 ppm of stabilizer for every 10 ppm of chlorine. I'll post the info below:

Undiluted dichlor is getting hard to find, but is available at Sams Club and via Amazon. It's sometimes available at Lowes or Home Depot, but you'll need to be a expert label-reader to recognize it!

PoolBrand granular dichlor 50lbs @ Sams Club => ~$2.20/lb (May 2014 in Chattanooga)
PoolBrand dichlor bagged shock 24lbs @ Sams Club => ~$2.50/lb (May 2014 in Chattanooga)

Kem-Tek dichlor 22 lbs @ Amazon => ~$3.50/lb (May 2014)
Kem-Tek dichlor 12 lbs @ Amazon => ~$4.10/lb (May 2014)
Kem-Tek dichlor 5 lbs @ Amazon => ~$5.00/lb (May 2014)
Kem-Tek dichlor 2 lbs @ Amazon => ~$9.00/lb (May 2014)

Keep in mind that Amazon products normally ship free; and that in many parts of the country, you will not have to pay sales tax. Shipping + tax can increase the cost from other suppliers by 15 - 40%, so compare delivered cost, not nominal price.