Re: Holy Chlorine, Batman!!
Yikes. What was he thinking?
Re: Holy Chlorine, Batman!!
Jeeez. That's pretty high. I bet he's going to need a TON of borax to get his pH up. I'm sure it's below 6.8. It's gotta be if he burned enough tabs to get to 44 ppm Cl
Michael
Re: Holy Chlorine, Batman!!
Michael,
I forgot to add that that his pH was 7.2 the second time I tested for him (10 days after the 44 - FC.) I have no idea how that was possible. :)
Re: Holy Chlorine, Batman!!
Wow!! At a CYA or 120+, he would need to be at 25 PPM to shock the pool....44 is crazy. What about his hair and swimsuit....did he notice anything bleaching??
Re: Holy Chlorine, Batman!!
Quote:
Originally Posted by duraleigh
Here's what I got
FC - 44
TC - (what's the point?)
pH - 6.8 - 6.9
Alk - 80
CYA - 120 plus
...
Amazingly, 10 days later of adding nothing and his FC is down to 22 and his liner DID NOT fade one bit. I'm assuming the buffering of the CYA protected him....I can think of no other reason he has any color at all in his liner.
Actually, such posts have quite a bit of value, at least to me. They provide me with external confirmation of some of the points I've made here. For example, I assume he'd been swimming in the pool with no observed ill effects? That's what I'd expect, but it's totally contrary to what's found in all the literature.
Ben
"PoolDoc"
Re: Holy Chlorine, Batman!!
Quote:
Originally Posted by vanhout
Yikes. What was he thinking?
With most test methods, there's no way to determine 44 ppm. OTO will be dark orange at that level; DPD tabs will be clear. So, he may have thought his chlorine was too LOW!
Quote:
Originally Posted by duraleigh
I forgot to add that that his pH was 7.2 the second time I tested for him (10 days after the 44 - FC.) I have no idea how that was possible.
The Taylor reagents are stabilized against chlorine, but not to 44 ppm. As far as I know, the only reliable method of testing pH, when the chlorine is that high, is a RECENTLY CALIBRATED pH meter.
Ben
"PoolDoc"
Re: Holy Chlorine, Batman!!
Hi, Ben,
No swimming yet. We're in Raleigh, NC, and while my pool is temporarily drained, I suspect most pool temps to be in the 60's.
He's a mercenary sort of guy......maybe we could all chip in and get him to take a dip.....see if he turns into an albino!! KIDDING! KIDDING! KIDDING!:D
Yesterday (10 days after the 44 FC) was when I got the 7.2 pH and 22ppm Cl.
Actually, one good result. After seeing Ben's kit, I'm pretty sure he is a convert and will be ordering the PS234 in the very near future
Re: Holy Chlorine, Batman!!
How could his pH go up? Is his pool open? Is the filter running? Then let's not forget our T/A lowering procedure....
"...then when the pH is below 7.2, aerate your water to raise pH..."
So his water is aerating and raising the pH.
Of course, this assumes that the 7.2 is vaguely accurate given Ben's caveats.
Re: Holy Chlorine, Batman!!
FYI....I just changed my 9 year old liner DIY...18X36 sport pool, 20k gallons, filling back up right now.
When the pool was installed in late fall, they added EIGHT gallons of 12% pool bleach. No pump to circulate, they left everything winterized. Told me to add EIGHT gallons again in the spring. After the spring, I learned not to do that again but also didn't notice any sudden fading. But over time....it certainly did, almost all the color was gone from the bottom despite being very conservative relative to shocking and chlorine levels.
But that's not all. After draining the pool I had my box cutter ready to section it for removal. Came in handy for the sides as they were still pliable, but the bottom? My index finger cut right through it turning it to glass like shards. More like thin plastic than vinyl. Popped and snapped any where I touched it. Had we not changed it this year somebody's foot would have gone right through it along the coves where it pulled back.
Just an FYI...sometimes the evidence of over chlorination shows up later...Tony