Aqualink RS enabling Jandy Heater

We have had the above equipment for about 8-9 years. I have always had to RE-Enable the Aqualink at the heater after a power outage because it would go back to "Disabled" due to the interruption, which was a pain but duable.
Then about 3 months ago I called a dealer for a service as I was having "Phantom Programs and the system needed to be reprogrammed. A very sharp tech came out and did the reprograming. I told her about the RE-ENABLING issue after power outages and she said she could fix that as well. And she did. It worked just fine. The way she described it was she was going to let the Aqualink panel do the thinking not the heater. Ten days ago we had another outage and now it stays on. I must throw the breaker to stop it. I called the same dealer for another service call and the original Tech has since left the state and the new one had no idea what she had done and thought there must be something bad in the heater board....probably a costly fix. So I consented to manually operating the heater. Now that I have thought about it more, manual operation sucks since My spa buttons do not work and running out to the heater to turn it on is just not good. I want to go back to before and have to RE-Enable the aqulink. BTW, it now shows Aualink enabled but only runs manually off the heater panel but otherwise runs great. Ideas anyone?