Hello all, First post here. I'm not sure if I'm supposed to open up with a joke or if I can dive right in.... Anyway, I have a 2HP Maxi-Pump...
First I needed to fix the green water after being gone for a couple of months. Then I needed to replace the pool pump (I'm now running a Pentair...
"+ asking a question about your pool (if you have one) + and then making a new post telling us you've done so and asking us to re-score your...
I just registered yesterday and when I try and search I get an error saying I don't have permissions
New member with a new in ground pool. Looking forward to using this site for all my Q&A
Can someone tell me how to figure the MINIMUM flow rate of a sand pump filter? Trying to determine if we can place a skimmer on this pool & what...
Hello, We have a 21,000 fiberglass pool installed by Fibertech in the early 200's and there are certain areas that look as if the fiberglass is...
Does anyone know of a reputable pool company that replaces & installs in ground vinyl pool liners in the Jacksonville, Fl area?
Just started to setup. I am putting the pool in an area with pea gravel and compacted earth beneath it. I bought pavers to use with the supports, but...
Hello folks, problem we have is a hairline crack in the side of our 332 Pentair filter housing, if you know how the newer Housings look, right below...
Hello: I live in SW Michigan and have a rectangular, gunite pool. It is 36' x 18' and holds approximately 30,000 gallons. I have lived here and...
I am a new member moving into a house with a pool. I took pictures of everything and was looking for some help
Just had our 30k gallon in ground pool re-plastered using Quartzscape. We filled the pool yesterday and I started the pump last night. Today I...
I was reading the sticky for new users. It mentioned providing a real address to help escape moderation. Where can I do that? I'm not able to access...
Needed to replace the light fixtures for my 2 pool lights. I cut the old wire at the light. Soldered the wires from the old wire to the new wire and...
Hello, Over the last few years, I've been spending a HUGE amount of money trying to maintain our pool. I've researched and saw this information a...
Hi. I have an 18x36 inground pool. Had it for about 20 years now. Last fall I had a new liner installed. I was losing water, so I had the lines...
I have an L-shaped in-ground pool. Anybody here knows how to get a winter cover? Thanks.
Brand spanking new AGP owner/operator/maintainer/and the one who will get all the blame. I`ve had a 35K inground for 12 years and am familiar with...
I`ve seen, can`t remember where, something about breaking up your pump/filter run times into blocks. Like, if you normally run your system for 6...
I just hookup a the intex skimmer and vacuum and all of a sudden the vacuum release cap started shooting out water like it had a small crack at the...
Question about converting pool A little about myself, I am a first time pool owner and have limited knowledge about pools. For the past two years, I...
So I ordered a SWG for my pool and it should be here in the next few days. The questions is, do I need to do anything to the pool to prep it? Do I...
I was inspired for doing a DIY gunite pool being owner/builder hiring individual contractors vs contracting out to pool company. Am I crazy or is...
Hi All! I'm new to the forum, as well as a first time pool builder/owner/maintainer and an aiming to start building a small, rectangular...
I have a Pentair/Sta-Rite System 3 cartridge filter. The filter is 1 year old. Last year it ran without issue. This summer, I took on the pool...
My new 24 ft round pool was setup last week. The pool company wants me to use Pure N Blue (their brand) but I don't want to. I've read about the...
A city inspector told us that the conduit at a light niche must be sealed with caulking. Has anyone heard of this before? I know the ground...
I have a 21 year old in ground, concrete pool. I had the entire pool refinished about ten years ago after the tiles fell off. The pool has a...
Having multiple problems with Polaris 935
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules