Forum: --cleanup--

Has anyone done this to their Intex pool ? Wondering what skimmer you used and parts needed ?

Has anyone found a functional and effective pool alarm for a Intex Ultra Frame pool? I will soon be setting up a 15' x 48" Intex Ultra Frame. I...

I NEED HELP: 20,000 GAL. pool pebblebrite, PH 6.2 or lower, TA 125, CA 125, TDS 1980, HARDNESS 1000, tried adjusting PH with PH UP, of course TA went...

Just opened the pool and replaced all the sand in my Hayward filter. Pool equipment was running fine with a filter pressure reading of 17 psi and...

Should my intex 8110 always register and provide error codes and led lights? Fired mine up and I'm not sure if it's working right because I have no...

Thanks to the great info this site provides I was able to fix a Pool Heater issue without even opening my wallet!!

Hello, I just recently had a Intermatic T101R tripping my heater and my Pentair 1.5 hp pool pump. At first it worked fine but now it trips my 20 amp...

16x32 vinyl liner, Haywood de3600 filter, Haywood 3/4 hp pump, pentair heat pump , pressure in pump remains the same after backwash,replaced grids...

Scratching my head.. We just set up our new Intex Sand Filter Pump. I followed all instructions on the Sand Filter Pump for start up. I...

Hi Newbie from GA. 25,000 gallon gunite pool with salt system, Hayward equipment, sand filter, pool built in 2007

I have seen where I might be able to rewire my impower pump to run on high all the time since it will not allow me to reset it. As you have seen...

My pool company replaced my old Polaris with the new TR36P. Seemed to work fine at first moving around regularly but now mostly just sits in place...

Can anyone yell me when adding acid to my pool if my SWG sbould remain running or turned off and just the pump running Thank you

My pool bulb blew. I replaced it and the new bulb flickers. I used a new gasket. I tested the bulb in an inside fixture. I used a multimeter to make...

I have just purchased a home with a 35,000 gallon inground pool. My wife went out and bought the taylor k1004 drop test kit. The question I have is...

Hi Im from Missouri and just got a Intex 12 x 24 above ground pool with sand filter and saltwater system

We had new walls and liner installed in 2010. The walls are showing cracks and bowing on the outside. We are concerned that this could cause a wall...

Hello We open our I ground vinyl pool yesterday to a disappointing surprise of the water is all the way down. The shallow part has about 3" of water...

Hi All, From some of the threads I have seen, the owner Ben went missing around 2 years ago. Is this still the case and new users aren't being...

I am just posting my first post. I know last year I had a very hard time with the pool (intex 30inx12ft) and trying to keep it clear. It is mainly...

Just installed new inground liner, gasket kit i ordered is different than my original. Original had gasket under liner with plastic strip (with no...

Hello, fellow pool people! Was going to read advice here in the forums on when sand needs to be replaced and so am registering and posting this...

water is not flowing through chlorinator, all other systems all o.k. Opened to full flow, still the same, no difference. No water in chlorinator....

Posting for the sake of posting here first?

Hi, looking for help here, I have an issue that started years ago that I cannot find anyone that can help with. My issue is with my 18'X36' inground...

I have a aqua confort pool heater model number AC-1250A and it won't switch out of defrost mode, would anyone know why and how to fix it?

Thanks for the add! I am looking forward to researching on how to make my pool better!

I'm a new pool owner. Looking for some advice on a solar cover. Heat generation, retention, etc.