+ Post New Thread
Page 1 of 2 1 2 LastLast
Threads 1 to 30 of 60

Forum: Pool Electronics

Questions about all sorts of pool equipment that is electronic, or controlled by electronics

  1. Aquacal Heat Wave not cooling….

    I have an Aquacal pool heater that runs and doesn't cool. It happend over a year ago and we had a repairman come out to fix it (it took him 10 mins)....

    Started by tchrist14‎, 11-11-2013 02:28 PM
    amz2fix
    • Replies: 3
    • Views: 60,888
    11-12-2013 08:25 AM Go to last post
  2. LED lights in salt pool dead within 3 years, Replace with ???

    CPHVLEDS100 Jandy LED lights first one was dead within 3 years, the 2nd one dead on open in year 4. Hardly ever used. Salt water pool LED's...

    Started by wishIcould‎, 05-19-2015 10:37 PM
    • Replies: 9
    • Views: 30,239
    05-20-2019 11:25 PM Go to last post
  3. iAqualink won't connect to Aquapure chlorine generator

    Just replaced my Jandy/Zodiac Aquapure control board with upgraded model so I can use iAqualink. Simple enough. Had the PDA version, pre 2007. Set...

    Started by Limestone‎, 03-23-2014 07:33 PM
    electronics, sticky
    • Replies: 5
    • Views: 21,497
    03-25-2014 07:20 PM Go to last post
  4. error code 170 on Aqualink RS Water Purification system

    How do I trouble shoot the following error code? "Possible Front board service condition or unit not correctly wired to 115 VAC"

    Started by JerryW‎, 05-08-2012 12:24 PM
    • Replies: 8
    • Views: 20,807
    05-09-2012 10:07 PM Go to last post
  5. Trouble with my Hayward EcoStar SVRS

    Not asking a question here but documenting some trouble I'm having with my fancy new high efficiency variable speed pump. I submitted the the...

    Started by BigDave‎, 05-14-2012 10:25 AM
    • Replies: 1
    • Views: 19,623
    06-03-2012 12:29 PM Go to last post
  6. Hayward 3400 : Communication failed check wiring between display and drive

    My pool pump stopped working today. It is a Hayward 3400 SVP. The error code i am getting is. Check System communication failed check wiring...

    Started by Wraypau‎, 06-06-2016 11:20 PM
    • Replies: 0
    • Views: 19,187
    06-06-2016 11:20 PM Go to last post
  7. Adding a water auto fill valve to IG pool

    Just wondering if anyone has added one of these to their pool? I wish my pool was plumbed for it but it's not and during the hot AL summers I'm...

    Started by Zac851‎, 03-29-2015 03:24 AM
    • Replies: 4
    • Views: 18,995
    04-06-2015 12:42 PM Go to last post
  8. Anyone have a hook into Hayward Parts?

    Hey Guys / Gals, Hope everyone is doing well...... so glad it's summer! My water and yard are looking great. Just got back from 9 days on the...

    Started by cooper‎, 06-18-2014 10:05 PM
    • Replies: 1
    • Views: 14,798
    06-19-2014 11:41 AM Go to last post
  9. New to forum - question about Jandy Aqualink RS8 6700 REV C with solar heating

    Hello, I am new to the forums. I have a Jandy Aqualink 6700 REV C with RS8 controller. I recently had solar heating panels installed and had a JVA...

    Started by pohoda‎, 06-07-2012 03:04 AM
    • Replies: 6
    • Views: 14,132
    06-10-2012 06:29 PM Go to last post
  10. New Pool Control

    Hi, My old Hayward system fired during lightning. Have lightning rods now and surge protection now. What is the best system? I like the...

    Started by STEPHAN‎, 11-20-2015 07:03 AM
    • Replies: 5
    • Views: 14,061
    11-25-2015 08:35 PM Go to last post
  11. Jandy Activator wiring question - newbie

    Long-time pool owner.... new to the forum. I just had a Zodiac iAqualink controller installed. It replaced a 16-year-old Aquadyne Mini panel. The...

    Started by tombeaux‎, 05-19-2014 10:16 PM
    • Replies: 2
    • Views: 13,891
    06-19-2014 09:54 AM Go to last post
  12. iAquaLInk as only control?

    Hi I replaced my aging Jandy Ji8000 with the new iAqualink bundle. Now the iAqualink is my only scheduling and control device (outside of the...

    Started by billythec‎, 06-10-2012 12:27 PM
    • Replies: 7
    • Views: 13,811
    06-10-2013 11:17 AM Go to last post
  13. RayPak 2100 finally will not ignite....

    It's been a little touchy lately, but now when I turn on the heater, I just get a click at 5 seconds, and a faint smell of gas. My guess is that the...

    Started by pmaru77‎, 06-06-2014 11:14 PM
    • Replies: 1
    • Views: 13,750
    06-08-2014 04:44 PM Go to last post
  14. Spillover on while hot tub is heating

    Hi, I have just encountered a problem with the spillover on my hot tub. When I activate the hot tub (heating etc) the spillover stays on (obviously...

    Started by roswell42‎, 06-10-2014 09:15 AM
    • Replies: 0
    • Views: 13,669
    06-10-2014 09:15 AM Go to last post
  15. Angry Wiring a Hayward EcoStar 3400 VSP

    I have swapped my old inefficient pump with a Hayward Ecostar SP3400 VSP. The plumbing is complete; however, my breaker keeps tripping when I start...

    Started by Shifty‎, 05-16-2015 04:56 PM
    • Replies: 0
    • Views: 13,653
    05-16-2015 04:56 PM Go to last post
  16. Should I remove Doughboy ozone purification controller

    I just had my liner replaced 30 days ago after 1.5yrs due to liner seam failure.13,700 gal Originally used all bioguard stuff that the pool store...

    Started by rajung‎, 07-02-2014 09:27 AM
    • Replies: 2
    • Views: 13,514
    07-03-2014 07:42 AM Go to last post
  17. Hot box

    Early Spring we converted to a Jacuzzi Saniclear 40 salt system. The box that is on the house gets VERY hot. This morning when I turned it on it...

    Started by Fiveattripp‎, 07-19-2016 07:52 PM
    • Replies: 3
    • Views: 13,471
    07-26-2016 05:31 PM Go to last post
  18. Wiring diagram - X10 to control 2 speed pump request

    Several years ago I asked for a wiring diagram for using my X10 remote to control my 2 speed waterfall pump, it gave me remote control of the low and...

    Started by RocKKer‎, 05-05-2015 12:03 AM
    • Replies: 0
    • Views: 13,146
    05-05-2015 12:03 AM Go to last post
  19. Aquapure Ei won't connect to iAqualink

    I have checked the wiring and installation, all is good there. Can't get the Aquapure ei to connect to the iaqualink. Any suggestions?

    Started by denjen‎, 06-25-2014 03:07 AM
    • Replies: 2
    • Views: 12,722
    06-26-2014 07:22 PM Go to last post
  20. For a new pool instal what is the best pool controller?

    We are installing a 17x35 shotcrete pool with a 7x8 spa and automatic pool cover. The coping was just poured. I would like to have a pool...

    Started by capool‎, 05-19-2014 01:14 AM
    • Replies: 1
    • Views: 12,130
    05-20-2014 09:09 PM Go to last post
  21. Pool control panel....Aqua plus

    I have a 18x36 in ground salt water pol that is about 6 years old. I currently have a Hayward Aqua plus gold line control. I am starting to have...

    Started by Bamafans‎, 05-04-2014 03:45 PM
    • Replies: 1
    • Views: 11,856
    06-01-2014 09:20 AM Go to last post
  22. Lightbulb Auxilary Lighting Problem

    I have 3 pole lights around my pool that have stopped working. I ran a diagnostic on my Aquling RS8 and it showed the solar Aux3 circuit "open"...

    Started by roswell42‎, 06-09-2014 11:59 AM
    • Replies: 3
    • Views: 11,806
    06-10-2014 10:57 PM Go to last post
  23. AquaLogic lightning problem

    Hi, I am happy I found this great forum. Hope you guys apologize my English; I am German but live in Florida since a while, still working on my...

    Started by STEPHAN‎, 07-21-2012 04:53 PM
    bonding, gfci, grounding, nec
    • Replies: 7
    • Views: 11,661
    07-23-2012 10:50 PM Go to last post
  24. Hayward Aqua Logic losing time

    I have an Aqua logic control that wont keep time, I have to manually change the day and time everyday, could not find any backup battery and the pool...

    Started by SWANY‎, 08-14-2018 05:38 PM
    • Replies: 4
    • Views: 11,485
    08-15-2018 10:18 PM Go to last post
  25. aqua link rs6

    all the lights where coming on on my indoor panel. codes 6700 rev c and 8157 rev I replaced nine volt battery outside in control box. indoor...

    Started by minivoks‎, 06-11-2014 05:24 PM
    • Replies: 1
    • Views: 10,887
    06-14-2014 02:43 PM Go to last post
  26. Whole pool without power

    We have an L-shaped vinyl inground pool with attached spa, which is about 15 years old. It therefore has two separate pumps -- a main pump and one...

    Started by Jodester‎, 08-31-2013 02:21 PM
    • Replies: 7
    • Views: 10,781
    09-09-2013 07:58 PM Go to last post
  27. Replacing 2speed pump...only working on low

    We replaced our 2speed pump with a pentair super flo 2speed pump. Our existing wires were 2 blue hot and 1 green ground. We plugged the hot in and...

    Started by Fiveattripp‎, 04-25-2016 02:15 PM
    • Replies: 3
    • Views: 10,778
    07-24-2016 11:36 PM Go to last post
  28. Aqualink RS enabling Jandy Heater

    We have had the above equipment for about 8-9 years. I have always had to RE-Enable the Aqualink at the heater after a power outage because it would...

    Started by Dry Rot‎, 04-05-2014 11:35 AM
    • Replies: 1
    • Views: 10,748
    04-06-2014 09:01 AM Go to last post
  29. Pool heater connection issue

    Hello all, my first post here. I just installed a Starite Maxitherm heater where an ancient Teleydne was. The Starite can be connected to a Jandy...

    Started by mccauley444‎, 05-31-2013 01:49 PM
    amz
    • Replies: 8
    • Views: 10,671
    06-08-2013 02:08 PM Go to last post
  30. Jakel or Fasco Part # needed for Hayward Blower

    I have a Hayward H100ID1 that needs a new blower, I know the blower / moor is made by Jakel. I also see that Fasco makes an upgrade but I'm...

    Started by cooper‎, 06-19-2014 09:07 AM
    • Replies: 0
    • Views: 10,617
    06-19-2014 09:07 AM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts