+ Post New Thread
Page 1 of 2 1 2 LastLast
Threads 1 to 30 of 60

Forum: Pool Electronics

Questions about all sorts of pool equipment that is electronic, or controlled by electronics

  1. LED lights in salt pool dead within 3 years, Replace with ???

    CPHVLEDS100 Jandy LED lights first one was dead within 3 years, the 2nd one dead on open in year 4. Hardly ever used. Salt water pool LED's...

    Started by wishIcould‎, 05-19-2015 10:37 PM
    • Replies: 9
    • Views: 30,234
    05-20-2019 11:25 PM Go to last post
  2. error code 170 on Aqualink RS Water Purification system

    How do I trouble shoot the following error code? "Possible Front board service condition or unit not correctly wired to 115 VAC"

    Started by JerryW‎, 05-08-2012 12:24 PM
    • Replies: 8
    • Views: 20,807
    05-09-2012 10:07 PM Go to last post
  3. Pool heater connection issue

    Hello all, my first post here. I just installed a Starite Maxitherm heater where an ancient Teleydne was. The Starite can be connected to a Jandy...

    Started by mccauley444‎, 05-31-2013 01:49 PM
    amz
    • Replies: 8
    • Views: 10,671
    06-08-2013 02:08 PM Go to last post
  4. iAquaLInk as only control?

    Hi I replaced my aging Jandy Ji8000 with the new iAqualink bundle. Now the iAqualink is my only scheduling and control device (outside of the...

    Started by billythec‎, 06-10-2012 12:27 PM
    • Replies: 7
    • Views: 13,811
    06-10-2013 11:17 AM Go to last post
  5. AquaLogic lightning problem

    Hi, I am happy I found this great forum. Hope you guys apologize my English; I am German but live in Florida since a while, still working on my...

    Started by STEPHAN‎, 07-21-2012 04:53 PM
    bonding, gfci, grounding, nec
    • Replies: 7
    • Views: 11,661
    07-23-2012 10:50 PM Go to last post
  6. Whole pool without power

    We have an L-shaped vinyl inground pool with attached spa, which is about 15 years old. It therefore has two separate pumps -- a main pump and one...

    Started by Jodester‎, 08-31-2013 02:21 PM
    • Replies: 7
    • Views: 10,781
    09-09-2013 07:58 PM Go to last post
  7. New to forum - question about Jandy Aqualink RS8 6700 REV C with solar heating

    Hello, I am new to the forums. I have a Jandy Aqualink 6700 REV C with RS8 controller. I recently had solar heating panels installed and had a JVA...

    Started by pohoda‎, 06-07-2012 03:04 AM
    • Replies: 6
    • Views: 14,132
    06-10-2012 06:29 PM Go to last post
  8. iAqualink won't connect to Aquapure chlorine generator

    Just replaced my Jandy/Zodiac Aquapure control board with upgraded model so I can use iAqualink. Simple enough. Had the PDA version, pre 2007. Set...

    Started by Limestone‎, 03-23-2014 07:33 PM
    electronics, sticky
    • Replies: 5
    • Views: 21,497
    03-25-2014 07:20 PM Go to last post
  9. New Pool Control

    Hi, My old Hayward system fired during lightning. Have lightning rods now and surge protection now. What is the best system? I like the...

    Started by STEPHAN‎, 11-20-2015 07:03 AM
    • Replies: 5
    • Views: 14,059
    11-25-2015 08:35 PM Go to last post
  10. Hello ! New member here. I want to add color lights to my pool.

    I have a 2 y.o. salt water pool with Pentair Easy Touch panel (and remote). I would like to look into replacing my pool and spa lights with the...

    Started by need-for-speed‎, 07-07-2012 08:54 PM
    • Replies: 4
    • Views: 8,005
    07-08-2012 03:12 PM Go to last post
  11. Anyone replace a Faulty J7 Connector on Sta-Rite Max-e-Therm?

    Had a power surge of some origin. Have replaced fuses and control board and have now nailed it down to an intermittent/faulty j7 connector...

    Started by dnspade‎, 08-14-2012 11:26 PM
    • Replies: 4
    • Views: 7,613
    08-15-2012 06:24 PM Go to last post
  12. LM2 24 Power Board schematic

    Hi, I have a LM2 24 and I have an issue with the power board. Specifically, the R26 resistor is burnt and the C19 cap looks about ready to go, if...

    Started by TommyV‎, 06-02-2013 03:59 PM
    • Replies: 4
    • Views: 8,643
    06-04-2013 07:51 AM Go to last post
  13. Adding a water auto fill valve to IG pool

    Just wondering if anyone has added one of these to their pool? I wish my pool was plumbed for it but it's not and during the hot AL summers I'm...

    Started by Zac851‎, 03-29-2015 03:24 AM
    • Replies: 4
    • Views: 18,993
    04-06-2015 12:42 PM Go to last post
  14. Hayward Aqua Logic losing time

    I have an Aqua logic control that wont keep time, I have to manually change the day and time everyday, could not find any backup battery and the pool...

    Started by SWANY‎, 08-14-2018 05:38 PM
    • Replies: 4
    • Views: 11,484
    08-15-2018 10:18 PM Go to last post
  15. next step on my basic controls

    i would like to hook this stuff up to a controller . maybe wireless . basic ,right now I just have 4 contactors .filter pump .waterfall pump....

    Started by vinper‎, 06-10-2013 05:49 PM
    • Replies: 3
    • Views: 8,105
    08-18-2013 07:57 AM Go to last post
  16. Question UV system for pools?

    New here but would like to know if anyone has used a uv system?

    Started by prancer100‎, 07-02-2013 02:30 PM
    • Replies: 3
    • Views: 7,978
    07-24-2013 01:36 PM Go to last post
  17. Aquacal Heat Wave not cooling….

    I have an Aquacal pool heater that runs and doesn't cool. It happend over a year ago and we had a repairman come out to fix it (it took him 10 mins)....

    Started by tchrist14‎, 11-11-2013 02:28 PM
    amz2fix
    • Replies: 3
    • Views: 60,888
    11-12-2013 08:25 AM Go to last post
  18. Lightbulb Auxilary Lighting Problem

    I have 3 pole lights around my pool that have stopped working. I ran a diagnostic on my Aquling RS8 and it showed the solar Aux3 circuit "open"...

    Started by roswell42‎, 06-09-2014 11:59 AM
    • Replies: 3
    • Views: 11,804
    06-10-2014 10:57 PM Go to last post
  19. Replacing 2speed pump...only working on low

    We replaced our 2speed pump with a pentair super flo 2speed pump. Our existing wires were 2 blue hot and 1 green ground. We plugged the hot in and...

    Started by Fiveattripp‎, 04-25-2016 02:15 PM
    • Replies: 3
    • Views: 10,777
    07-24-2016 11:36 PM Go to last post
  20. Hot box

    Early Spring we converted to a Jacuzzi Saniclear 40 salt system. The box that is on the house gets VERY hot. This morning when I turned it on it...

    Started by Fiveattripp‎, 07-19-2016 07:52 PM
    • Replies: 3
    • Views: 13,469
    07-26-2016 05:31 PM Go to last post
  21. Pool Alarms

    We are considering a pool alarm (like the one where water disturbance sounds an alarm in case a child falls in). However, I've reviewed many of...

    Started by bikemark99‎, 08-10-2018 04:22 PM
    • Replies: 3
    • Views: 4,678
    08-10-2018 10:04 PM Go to last post
  22. Need Hayward OnCommand System info & manual

    Hello All, I'm new to the Salt Water Pool ownership and had a few questions about the Hayward OnCommand System currently installed. It seems to...

    Started by rupp179‎, 06-03-2018 07:46 PM
    • Replies: 2
    • Views: 4,170
    06-03-2018 11:24 PM Go to last post
  23. OnCommand Question.

    Looking for a little Info. I was given a brand new Hayward OnCommand controller and a Hayward 11KW spa heater. I have not recived it yet, it is...

    Started by kculm‎, 07-07-2012 12:20 PM
    • Replies: 2
    • Views: 6,459
    07-07-2012 12:27 PM Go to last post
  24. aqualink rs8 problem

    my poolman replaced a relay and then when a program didn't work properly, he deleted the memory. we restarted the rs8 and now the programs work...

    Started by dir1944‎, 06-03-2013 11:36 AM
    • Replies: 2
    • Views: 6,877
    06-04-2013 08:25 AM Go to last post
  25. Autopilot soft touch calibration

    Does anyone know if the temperature can be calibrated, or does it even matter for optimum generation

    Started by Bullethead1959‎, 06-04-2013 06:35 PM
    • Replies: 2
    • Views: 7,535
    06-08-2013 09:16 AM Go to last post
  26. Simple Chlorine generator cell control??????

    Given all the troubles with the Aquarite and others control boards, has anyone ever developed/built/invented a simple, sort of manual control for the...

    Started by airbrush‎, 08-31-2013 06:34 AM
    • Replies: 2
    • Views: 6,304
    08-31-2013 02:54 PM Go to last post
  27. Jandy Activator wiring question - newbie

    Long-time pool owner.... new to the forum. I just had a Zodiac iAqualink controller installed. It replaced a 16-year-old Aquadyne Mini panel. The...

    Started by tombeaux‎, 05-19-2014 10:16 PM
    • Replies: 2
    • Views: 13,890
    06-19-2014 09:54 AM Go to last post
  28. Should I remove Doughboy ozone purification controller

    I just had my liner replaced 30 days ago after 1.5yrs due to liner seam failure.13,700 gal Originally used all bioguard stuff that the pool store...

    Started by rajung‎, 07-02-2014 09:27 AM
    • Replies: 2
    • Views: 13,509
    07-03-2014 07:42 AM Go to last post
  29. Aquapure Ei won't connect to iAqualink

    I have checked the wiring and installation, all is good there. Can't get the Aquapure ei to connect to the iaqualink. Any suggestions?

    Started by denjen‎, 06-25-2014 03:07 AM
    • Replies: 2
    • Views: 12,722
    06-26-2014 07:22 PM Go to last post
  30. Aqualink RS enabling Jandy Heater

    We have had the above equipment for about 8-9 years. I have always had to RE-Enable the Aqualink at the heater after a power outage because it would...

    Started by Dry Rot‎, 04-05-2014 11:35 AM
    • Replies: 1
    • Views: 10,748
    04-06-2014 09:01 AM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts