+ Post New Thread
Page 1 of 2 1 2 LastLast
Threads 1 to 30 of 60

Forum: Pool Electronics

Questions about all sorts of pool equipment that is electronic, or controlled by electronics

  1. Simple Chlorine generator cell control??????

    Given all the troubles with the Aquarite and others control boards, has anyone ever developed/built/invented a simple, sort of manual control for the...

    Started by airbrush‎, 08-31-2013 06:34 AM
    • Replies: 2
    • Views: 6,304
    08-31-2013 02:54 PM Go to last post
  2. Recommended Solar Heater Controller

    I currently have a HelioMatic cm4000 solar controller that is defective..apparently the actuator is bad also. So I was looking to replace them both...

    Started by ArmyChief‎, 03-05-2013 03:25 PM
    • Replies: 0
    • Views: 5,172
    03-05-2013 03:25 PM Go to last post
  3. Intermatic PX100 Lighting Transformer

    Well the pool light went out a few nights ago and I troubleshoot it today. Seems the secondary on my Intermatic PX100 is open. I've did a google...

    Started by ArmyChief‎, 07-09-2013 04:48 PM
    • Replies: 1
    • Views: 9,594
    08-17-2013 06:12 PM Go to last post
  4. Urg. I have no idea what to with this.

    Hey ya'll! I just ordered a Pentair IntelliFlo VF Variable Flow High Performance pool pump, and I was wondering how to upgrade my system to automate...

    Started by awhite6455‎, 06-09-2012 08:08 PM
    automation
    • Replies: 1
    • Views: 7,890
    06-10-2012 12:18 PM Go to last post
  5. Pool control panel....Aqua plus

    I have a 18x36 in ground salt water pol that is about 6 years old. I currently have a Hayward Aqua plus gold line control. I am starting to have...

    Started by Bamafans‎, 05-04-2014 03:45 PM
    • Replies: 1
    • Views: 11,860
    06-01-2014 09:20 AM Go to last post
  6. Trouble with my Hayward EcoStar SVRS

    Not asking a question here but documenting some trouble I'm having with my fancy new high efficiency variable speed pump. I submitted the the...

    Started by BigDave‎, 05-14-2012 10:25 AM
    • Replies: 1
    • Views: 19,623
    06-03-2012 12:29 PM Go to last post
  7. Pool Alarms

    We are considering a pool alarm (like the one where water disturbance sounds an alarm in case a child falls in). However, I've reviewed many of...

    Started by bikemark99‎, 08-10-2018 04:22 PM
    • Replies: 3
    • Views: 4,681
    08-10-2018 10:04 PM Go to last post
  8. iAquaLInk as only control?

    Hi I replaced my aging Jandy Ji8000 with the new iAqualink bundle. Now the iAqualink is my only scheduling and control device (outside of the...

    Started by billythec‎, 06-10-2012 12:27 PM
    • Replies: 7
    • Views: 13,811
    06-10-2013 11:17 AM Go to last post
  9. Pentair swg ic 40 red flow light

    My pool is 2 years old. I have a salt water system with a pentair ic 40. The red flow light is on. I have taken the unit off and cleaned with acid...

    Started by BStone‎, 04-24-2014 11:34 AM
    • Replies: 0
    • Views: 8,281
    04-24-2014 11:34 AM Go to last post
  10. Autopilot soft touch calibration

    Does anyone know if the temperature can be calibrated, or does it even matter for optimum generation

    Started by Bullethead1959‎, 06-04-2013 06:35 PM
    • Replies: 2
    • Views: 7,536
    06-08-2013 09:16 AM Go to last post
  11. For a new pool instal what is the best pool controller?

    We are installing a 17x35 shotcrete pool with a 7x8 spa and automatic pool cover. The coping was just poured. I would like to have a pool...

    Started by capool‎, 05-19-2014 01:14 AM
    • Replies: 1
    • Views: 12,134
    05-20-2014 09:09 PM Go to last post
  12. Fiberstars 6008 Pool Light Hot Mirror bracket assemby

    Hi, I just purchased a house with an inground pool that has this type of light. The light was extremely dim. When I took the assembly apart the...

    Started by CMill10‎, 06-27-2012 03:14 PM
    • Replies: 1
    • Views: 6,521
    06-28-2012 07:29 PM Go to last post
  13. Anyone have a hook into Hayward Parts?

    Hey Guys / Gals, Hope everyone is doing well...... so glad it's summer! My water and yard are looking great. Just got back from 9 days on the...

    Started by cooper‎, 06-18-2014 10:05 PM
    • Replies: 1
    • Views: 14,799
    06-19-2014 11:41 AM Go to last post
  14. Jakel or Fasco Part # needed for Hayward Blower

    I have a Hayward H100ID1 that needs a new blower, I know the blower / moor is made by Jakel. I also see that Fasco makes an upgrade but I'm...

    Started by cooper‎, 06-19-2014 09:07 AM
    • Replies: 0
    • Views: 10,621
    06-19-2014 09:07 AM Go to last post
  15. Aquapure Ei won't connect to iAqualink

    I have checked the wiring and installation, all is good there. Can't get the Aquapure ei to connect to the iaqualink. Any suggestions?

    Started by denjen‎, 06-25-2014 03:07 AM
    • Replies: 2
    • Views: 12,724
    06-26-2014 07:22 PM Go to last post
  16. aqualink rs8 problem

    my poolman replaced a relay and then when a program didn't work properly, he deleted the memory. we restarted the rs8 and now the programs work...

    Started by dir1944‎, 06-03-2013 11:36 AM
    • Replies: 2
    • Views: 6,877
    06-04-2013 08:25 AM Go to last post
  17. Anyone replace a Faulty J7 Connector on Sta-Rite Max-e-Therm?

    Had a power surge of some origin. Have replaced fuses and control board and have now nailed it down to an intermittent/faulty j7 connector...

    Started by dnspade‎, 08-14-2012 11:26 PM
    • Replies: 4
    • Views: 7,614
    08-15-2012 06:24 PM Go to last post
  18. Aqualink RS enabling Jandy Heater

    We have had the above equipment for about 8-9 years. I have always had to RE-Enable the Aqualink at the heater after a power outage because it would...

    Started by Dry Rot‎, 04-05-2014 11:35 AM
    • Replies: 1
    • Views: 10,748
    04-06-2014 09:01 AM Go to last post
  19. Pool light

    Hello! I live in the Sacramento Valley, CA and have a 1969 in ground plaster pool. I had the surrounding concrete replaced and found that the...

    Started by ESA1178‎, 07-02-2014 11:24 AM
    • Replies: 0
    • Views: 10,557
    07-02-2014 11:24 AM Go to last post
  20. Replacing 2speed pump...only working on low

    We replaced our 2speed pump with a pentair super flo 2speed pump. Our existing wires were 2 blue hot and 1 green ground. We plugged the hot in and...

    Started by Fiveattripp‎, 04-25-2016 02:15 PM
    • Replies: 3
    • Views: 10,782
    07-24-2016 11:36 PM Go to last post
  21. Hot box

    Early Spring we converted to a Jacuzzi Saniclear 40 salt system. The box that is on the house gets VERY hot. This morning when I turned it on it...

    Started by Fiveattripp‎, 07-19-2016 07:52 PM
    • Replies: 3
    • Views: 13,473
    07-26-2016 05:31 PM Go to last post
  22. Flow rate sensor?

    My pool system has an automatic Jandy valve that rotates between enabling the skimmers and enabling the pool vacuum port. Years ago, I "tuned" its...

    Started by henryb‎, 06-19-2013 06:10 PM
    • Replies: 1
    • Views: 7,091
    08-31-2013 02:51 PM Go to last post
  23. Intellibrite 5g multi color led light issue

    New pool with intellibrite 5g multi color light and intellibrite controller. Upon pushing the power button only the red lights up in all settings on...

    Started by Jabells‎, 05-18-2014 11:07 PM
    • Replies: 1
    • Views: 9,008
    05-20-2014 08:41 PM Go to last post
  24. error code 170 on Aqualink RS Water Purification system

    How do I trouble shoot the following error code? "Possible Front board service condition or unit not correctly wired to 115 VAC"

    Started by JerryW‎, 05-08-2012 12:24 PM
    • Replies: 8
    • Views: 20,807
    05-09-2012 10:07 PM Go to last post
  25. Whole pool without power

    We have an L-shaped vinyl inground pool with attached spa, which is about 15 years old. It therefore has two separate pumps -- a main pump and one...

    Started by Jodester‎, 08-31-2013 02:21 PM
    • Replies: 7
    • Views: 10,781
    09-09-2013 07:58 PM Go to last post
  26. Jandy (Zodiac) iAqualink Questions

    I have the Aqualink RS system now. The PDA failed so I have only manual control. Since replacements are no longer available Jandy suggested I...

    Started by JohnASmith‎, 05-05-2020 01:49 PM
    • Replies: 0
    • Views: 7,669
    05-05-2020 01:49 PM Go to last post
  27. OnCommand Question.

    Looking for a little Info. I was given a brand new Hayward OnCommand controller and a Hayward 11KW spa heater. I have not recived it yet, it is...

    Started by kculm‎, 07-07-2012 12:20 PM
    • Replies: 2
    • Views: 6,459
    07-07-2012 12:27 PM Go to last post
  28. iAqualink won't connect to Aquapure chlorine generator

    Just replaced my Jandy/Zodiac Aquapure control board with upgraded model so I can use iAqualink. Simple enough. Had the PDA version, pre 2007. Set...

    Started by Limestone‎, 03-23-2014 07:33 PM
    electronics, sticky
    • Replies: 5
    • Views: 21,497
    03-25-2014 07:20 PM Go to last post
  29. Fiber Optic Lighting DIY?

    I've come into (begun renting) a pool that appears to have a disregarded fiber optic lighting system. It appears to have circumference lighting under...

    Started by Luciendar21‎, 08-09-2018 01:29 AM
    • Replies: 1
    • Views: 4,487
    08-09-2018 07:32 AM Go to last post
  30. Storm safety

    I have a 10’ X 30” summer waves easy set pool. It is storming for the first time since I set up and I unplugged the filter and left the power adapter...

    Started by MagsKLB‎, 06-08-2018 06:30 AM
    • Replies: 1
    • Views: 4,274
    06-08-2018 07:00 AM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts