Forum: Pool Equipment & Operations

We have 40,000 gallon pool and for many seasons the pressure gage on our pump has read at 18 but the pool company said we needed a new one and after...

Anyone have any experience with the Hayward Colorlogic Generation 2.5 light not working? Worked fine when I opened the pool...... had it on 2...

What do you use to seal the coupler to the vac hose? Just put a new one on and get air leaks at skimmer end. TJG

i've recently had a pool installed. Looking at getting a mesh pool fence installed. are there any recommendations? pricing? should i pay for install...

I have a Hayward Vari-Flo xl model #sp0714c and I would like to replace the spider gasket. I cannot find this model on the internet. Would a sp0714t...

Greetings. I tried to do a search, but it said I didn;t have the "rights", I was hoping I could find the solution already posted. I am pushing...

Ok..there are my specs. I have been browsing (lurking) and learning from these forums since 2003 when I first got my AG pool (thanks to pooldoc,...

I have a error on the display that says HOT and there is nothing in the book that address's this any ideas thanks Jim

Opened the pool and tried to turn the heater on and it won't start. Its a Raypak P-R266A-EN-C. Getting a error code SNS in the display

Thanks for all the wealth of information posted here. I've been 'lurking' (I like to call it learning) since I am starting at ground zero. Basic...

I'm having some issues with my DE filter. When I clean and recharge it with the manufacturers recommended amount of DE (4.5lbs. For my 36sqft...

Hello, All. We have a 18 x 36 IG vinyl rectangular, and twice My Wife and I have woken up to debris being thrown in the pool. Sadly the liner is...

We are novice pool people. We purchased this pool used a few years ago. It is a super splash pool (10,000 galloons) Our pool filter is a 18"...

I have an older pool, maybe 20 yrs old. 20X40 9'deep. Hayward 244s filter. 2 jets. 2 skimmers. New liner. 1.5" pvc piping. 220v to pump motor....

Hello! I have a jandy lite 2 and it keeps turning off with an error fl 2. After cleaning and checking flame sensor I decided to give it a try and...

Hi all - Newbie question here: Where can I find a thread on calculators, past experiences, best practices, etc for replacing a 24-year old rooftop...

I just had to replace my hayward 1&1/2 motor and pump. I see the grounding lug on the outside of the motor. What is the the proper way to ground/or...

A friend gave us a Tagelus TD-40 filter that was on an inground pool. Is it ok to use this for an above ground pool?

I think I know the answer but.... My discharge into the pool is cloudy when I am vacuuming up the remains of the scum and dead algae from the bottom...

Hello All, I disassembled my filter two days ago to replace the o-ring that sits between the multiport and the tank flange, it wasn't leaking, but...

I have an inground pool that has a settling (foundation) problem. One side is slightly lower...which my skimmers are not the same level. My...

Hello all, Background - pool is inground 16 x 32. This will be our 3rd season, so pool is rather new. After opening my pool this past weekend,...

Hello. I have a 24 ft above ground pool. I cleaned up REALLY nasty water (think algae, tadpoles, leaves, and stinky) last year and I am working on...

I've read about Hayward spider gasket replacement here. Is there a place where these gaskets are typically purchased? Does Hayward company sell these...

Ya'll I have this grimmy, dirt looking crap in the bottom of my pool. Yesterday I used my little catfish vac and got it all up (so I thought) this...

I have had my above ground pool for 8 years. It's a 27' round that is dug out to 5.5 feet in the center. We are always in the pool, so even though I...

Would like to hear thoughts on solar covers. No which kind I buy, 8ml, 12 ml, blue or clear I only get 2 years out of them. We have a 24' round...

Ok, so I've got a rectangular in-ground pool. approx 13.5' x 24'. The shallow end is 3' deep and the deep end is 5' deep. There's not only a slope...

Missing the label showing the position for the valve. It is a Hayward Model NO. S190TSCP

I have a hayward perflex de filter system (ec65a) with a hayward 1.5 hp pump i just open the pool added earth to it and it "cloggs" up my pressure...