+ Post New Thread
Page 11 of 120 FirstFirst ... 9 10 11 12 13 21 61 111 ... LastLast
Threads 301 to 330 of 3587

Forum: Pool Equipment & Operations

Pumps, pipes, filters, lights; covers, valves, heaters, coolers; filling and draining . . .

  1. Sticky Thread Sticky: How Much Does Pump Efficiency Matter?

    ___________________________________ How Much Does Pump Efficiency Matter? ___________________________________ TL;DR: The difference in...

    Started by PoolDoc‎, 06-23-2018 09:02 PM
    • Replies: 0
    • Views: 1,171
    06-23-2018 09:02 PM Go to last post
  2. Sticky Thread Sticky: FAQs & Guides: Pool Equipment & Operations

    ____________________________________ FAQs & Guides: Pool Equipment & Operations ---- June 2018 ---- ____________________________________ ...

    Started by PoolDoc‎, 06-19-2018 05:06 PM
    • Replies: 0
    • Views: 1,275
    06-19-2018 05:06 PM Go to last post
  3. Sticky Thread Sticky: Need advice regarding cartridge filter...

    I've spent the last three years (yes, that's THREE) rebuilding my existing pool that was originally built in the mid 50's. Lots of problems, lots...

    Started by otisdog‎, 05-23-2014 03:45 PM
    • Replies: 9
    • Views: 8,247
    05-29-2014 10:38 AM Go to last post
  1. variable speed with heat pump and salt water generator

    If I'm running a variable speed pump on low rpms can this cause any issues with a salt chlorine generation system or the heat pump?

    Started by neverstopplaying‎, 06-18-2014 01:28 PM
    • Replies: 2
    • Views: 3,187
    06-19-2014 09:36 AM Go to last post
  2. newbie here.....filter is toast.....which filter should we get?

    Long story short.....we bought a house 8 months ago with a large inground "L" shaped pool. 18x42 with 18x20 L, so approx. 47,000 gals (it's...

    Started by cathicool‎, 06-15-2014 10:06 PM
    2 Pages
    1 2
    sticky, sticky-contractor, sticky-filter
    • Replies: 10
    • Views: 8,031
    06-18-2014 10:45 PM Go to last post
  3. Cool another pool season starts

    hello fellow pool enthusiasts! I read through a some posts a few years to bring up my knowledge of pool chemistry. This is one of the few places...

    Started by neverstopplaying‎, 06-17-2014 09:46 PM
    • Replies: 3
    • Views: 4,281
    06-18-2014 12:57 PM Go to last post
  4. Hayward pump cutting out several times a day - is this normal?

    I have a 30,000-gallon in-ground w/ a Hayward pump (SP2607X10). It's driven by a 1HP A.O Smith motor that runs on 220V. The pump is on a timer that...

    Started by Tommy‎, 07-07-2013 03:28 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 8,363
    06-18-2014 09:45 AM Go to last post
  5. Backwash

    Hi all, Newbie here and trying to figure out how to backwash a DE filter that has no handle. We bought a home that came with a: Proline...

    Started by rkovelman‎, 06-17-2014 09:49 PM
    • Replies: 1
    • Views: 3,200
    06-18-2014 08:06 AM Go to last post
  6. new variable speed pump and solar heating system

    Hello there, I had a new Hayward 3400VSP pump installed yesterday to replace a 5 year old 1.5hp hayward and it keeps getting stuck priming during...

    Started by michelleh220‎, 06-15-2014 03:01 PM
    • Replies: 1
    • Views: 3,274
    06-17-2014 03:42 PM Go to last post
  7. Solar cover straps?

    Any good leads on straps to connect my solar cover to the reel? I need a longer length, maybe 30-36". The reel is anchored hard into the concrete,...

    Started by glockshooter‎, 06-16-2014 10:42 PM
    • Replies: 0
    • Views: 2,226
    06-16-2014 10:42 PM Go to last post
  8. Size of skimmer vac hose opening - inground pool

    We have a new skimmer installed when our pool was renovated last year. I have a robot cleaner, so haven't had to use our vac hose till now. And I...

    Started by handy1‎, 06-15-2014 03:01 PM
    • Replies: 0
    • Views: 4,336
    06-15-2014 03:01 PM Go to last post
  9. pool filter time trippers turn-on, turn-off not working

    Hi, Our pool filter has a round dial with two trippers, one to turn on the filter, one to turn off the filter. In the past we could place the...

    Started by vinouspleasure‎, 06-15-2014 12:18 PM
    • Replies: 1
    • Views: 4,022
    06-15-2014 01:29 PM Go to last post
  10. Jandy Check Valve rusted spring

    Does anyone know of a replacement spring that can be purchased for Jandy Check Valve. "thanks for your input"

    Started by michaelfl‎, 06-13-2014 02:36 PM
    • Replies: 1
    • Views: 4,375
    06-14-2014 10:21 PM Go to last post
  11. Pool Heater size

    Hello all: I had a 400,000 BTU Raypack 2100 heater which died last month after 12 years. I had a new heater installed and asked for another...

    Started by RSM18‎, 06-12-2014 08:35 AM
    • Replies: 1
    • Views: 3,474
    06-14-2014 03:25 PM Go to last post
  12. Getting debris in return from Pentair DE filter, but no DE

    Hi, I recently had trouble with DE getting sent back into the pool from my Pentari 60" DE filter. You could see it coming thru the return. I...

    Started by pktivey‎, 06-11-2014 06:03 PM
    • Replies: 1
    • Views: 3,290
    06-14-2014 03:05 PM Go to last post
  13. Hayward H1501

    About 7 years old. I think I need a new gas valve. The heater does not start up. I jump across the terminals on top of the gas valve and usually...

    Started by curtis1512‎, 06-11-2014 02:51 PM
    • Replies: 1
    • Views: 2,480
    06-14-2014 01:39 PM Go to last post
  14. Is this causing sand to go into the pool?

    I pulled the top off my old Media Master 19" this morning because in the past 2 days it's belched an unusually large amount of sand into the pool. ...

    Started by Bosch232‎, 06-14-2014 09:32 AM
    • Replies: 0
    • Views: 6,221
    06-14-2014 09:32 AM Go to last post
  15. pentair dynamo pump issues

    hello new to the forum and looking for advice on my dynamo pump. My pump wouldn't start Monday evening after back washing, it just hummed. The motor...

    Started by bjreed1999‎, 06-11-2014 09:36 AM
    • Replies: 1
    • Views: 2,926
    06-13-2014 10:00 PM Go to last post
  16. Hayward H250 heater blowing fuses

    My Hayward heater ran for about 2 hours this spring and then blew the #2 position fuse on the AC supply side. I found a troubleshooting manual online...

    Started by windypool‎, 06-12-2014 10:52 PM
    • Replies: 0
    • Views: 5,762
    06-12-2014 10:52 PM Go to last post
  17. Pentair Clean and Clear

    We opened our Pentair Clean and Clear to change the filters and now that we have it closed back again, it is leaking around the seal. We have...

    Started by AllBoys‎, 06-10-2014 08:52 PM
    • Replies: 1
    • Views: 3,140
    06-12-2014 01:27 PM Go to last post
  18. Electricity and GFI tripping

    I have 24'round AG, about 12,000 gallons. The pump is only 2 or 3 years old and is probably 1 hp. I have an electrical circuit running the...

    Started by dalejanus‎, 06-11-2014 10:10 PM
    • Replies: 6
    • Views: 7,688
    06-12-2014 11:00 AM Go to last post
  19. De Filter EC40

    I would like to replace some of my Flex Tubes socks, but I can only find the tube with the socks. I've search and search the internet but no luck....

    Started by ltpowel‎, 06-11-2014 07:53 AM
    • Replies: 0
    • Views: 2,585
    06-11-2014 07:53 AM Go to last post
  20. Hayward SP 712 Valve, rebuild or replace?

    Well, i'm into my first real summer of pool ownership. I noticed a water leak in the top of my valve assembly, along with a tiny trickle of water...

    Started by glockshooter‎, 06-10-2014 11:57 PM
    • Replies: 0
    • Views: 3,619
    06-10-2014 11:57 PM Go to last post
  21. Question hayward power flo xl sand filter problems

    have used a power flow xl for 16 years and now on our 2nd replacement valve unit. 10000 gallon round above ground pool. runs nice for 45...

    Started by stevenmaggie‎, 06-08-2014 08:48 AM
    • Replies: 4
    • Views: 3,093
    06-10-2014 11:04 PM Go to last post
  22. high recirc pressure, Low filter pressure

    Hi All, I got an inground pool (with the house) a few years ago and this year I decided to open it myself and I'm running into problem. On...

    Started by cooter‎, 06-09-2014 10:30 AM
    • Replies: 2
    • Views: 2,512
    06-10-2014 08:56 PM Go to last post
  23. Need advice for replacement pool heater- Ours oil heater was "condemned".

    I have a 20k gallon in ground pool. Itís called a Grecian, I think. 20x40. The pool is heated by oil. We had our oil company come to service the pool...

    Started by Juhgail‎, 06-09-2014 12:02 PM
    • Replies: 2
    • Views: 4,213
    06-10-2014 03:44 PM Go to last post
  24. Pool pump ?

    Contract calls for all jandy equipment - pool builder says he wants to give us the most advanced jandy automated control system and in doing so he...

    Started by SoCal‎, 06-08-2014 04:45 AM
    • Replies: 3
    • Views: 3,279
    06-10-2014 03:15 PM Go to last post
  25. Question Low system pressure

    Hi. Since a few weeks I am battling low pressure in my pool system. At times, the pool pump can't even get over the priming cycle (Sta Rite...

    Started by rbienert‎, 06-08-2014 03:42 PM
    • Replies: 3
    • Views: 2,675
    06-10-2014 02:53 PM Go to last post
  26. Letro jet vac

    My sweep has stopped "backing up". Anyone know how to fix this?

    Started by Bobcat9095‎, 06-06-2014 01:17 PM
    • Replies: 4
    • Views: 2,988
    06-10-2014 02:22 PM Go to last post
  27. Low Flow over Spa Spillover

    I have an 8-year old pool, 12000 gal, with attached spa and spillover. After some re-plastering and re-attachment of spillover, our flow over the...

    Started by BranfordMcA‎, 06-07-2014 02:14 PM
    • Replies: 1
    • Views: 5,106
    06-08-2014 07:26 PM Go to last post
  28. Pump motor failure

    I'm stumped! So I opened my pool today, I thought "everything worked pretty well" kiss of death. Vacuumed the pool, shut down the pump switched to...

    Started by Subaru mike‎, 06-04-2014 06:22 PM
    • Replies: 6
    • Views: 5,702
    06-08-2014 11:36 AM Go to last post
  29. Red face Filter pump run time

    I need to lower my monthly electrical bill. I've had the pool for a few years now and the builder had suggested that I run the pump at the ratio of...

    Started by wet willy‎, 06-04-2014 10:08 AM
    • Replies: 5
    • Views: 6,791
    06-07-2014 07:50 PM Go to last post
  30. New to the forum

    Hi everybody, just bought a house with the pool. I think I have a sand filter. But now, it's not working I wish I could post pictures.

    Started by Abe7333‎, 06-04-2014 07:28 PM
    • Replies: 3
    • Views: 4,883
    06-07-2014 07:37 PM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts