Forum: Pool Equipment & Operations

Hello, we have an above ground pool with a PT deck on the end, at this time, we have a ladder(tubular sides) that mount thru a hole into the deck. I...

I bought a Hayward S210 filter last Friday and installed it. When I turned it on it had a small leak on top of filter. From what I read it might be...

I have a Jacuzzi Laser sand filter, Model 190L, it is about 25 years old. I have developed a pin hole leak in the body itself, and attempting to seal...

I have a Jacuzzi Laser sand filter, Model 190L, it is about 25 years old. I have developed a pin hole leak in the body itself, and attempting to seal...

Hi All. I am going to install a couple of New Diverters on my J350. To help them rotate a little easier/smoother, I plan to lubricate them with...

I upgraded our pool light to LED 4 years ago and we decided to go with the Pentair Intellibrite 5G. Unfortunately, it stopped working a couple of...

My pool pro says I need to drain half the water in my pool and refill with new water. Half the water is about 7,500 gallons. I don't want to run...

Help. I am trying to find the correct basket for my Jacuzzi pool pump. Everything I have found seems to have different dimensions. Is the Jacuzzi...

Hello all. I cannot get rid of fine layer of what i think is dead algae on inground pool. About 25k gallons. Have a sta rite 3 sand filter....

Polaris 380 does not run correctly With the booster pump on and (backup valve & Polaris disconnected from hose), I get low water pressure from...

Hi all, I've been dealing with a cloudy pool since I opened it last week. Usually with brushing, running the pool cleaner, getting the chemistry up...

Pool I have an above ground pool , just started up for the season. I have excessive back pressure coming thru skimmer after I shut off filter. A...

Pool I have an above ground pool , just started up for the season. I have excessive back pressure coming thru skimmer after I shut off filter. A...

My 9V backup battery came disconnected from my Jandy RS PCB, and I can't see how to reconnect it. There is a small screw on the top of the terminal...

I purchased a Jacuzzi JCQ 420 pool filter and have found that the filter cartridges keep failing. I would like to purchase replacement cartridges...

Hi all, My pool pump is going on 30 years old. This year the cover to the electrical hook up rusted away. The casing on the motor is pretty rusty...

SO i just bought a new Hayward Super pump 700. Had an electrician hook it up. It starts up at a normal high speed then kicks down to a slow speed,...

Hi, Recently I was talking with an acquaintance who also has an inground pool. She was telling me she had to replace the sand in her filter because...

Hi, I noticed this morning that my pump has become noticeably louder, and higher pitched; and I'm wondering if there's anything I can do,...

I am replacing my inline chlorinator (the cylinder type you drop tablets into.) My question is, because it must remain upright, when screwing in to...

We are planning on replacing our 21 year old TR 60 Sand Filter this season along with the multi-Port. We have our pool covered for the winter. Plan...

Looking for a new salt water filer. I currently have a 20 year old cracked Hayward DE. My pool is 13Kgal I know my Hayward DE was real good but...

So all around the edges my maaco pool cover is wearing due to a lip, especially corners. Can I use waterproof gorilla patch & seal tape vs. buying...

#1 I have to replace my current pool pump, a Hayward 3400VSP, as the drive has went out again (2nd time) and I have already replaced 4 motors. The...

I have a Hayward 3400VSP pool pump. I have went through 4 motors in last 6 years. I am unsure if a motor should only last this long, or if they are...

I'm in San Diego. Water evaporation is expensive. My water bill last year was $750 for 2 months I think I've cut it in half by doing bubble...

Is this normal. In Spa mode only I'm pulling 20 psi. When I put pool and spa I'm pulling 30 psi

Polaris Floor Cleaner does not come on in normal mode When I put it in service mode the motor does turn on but the Polaris never moves

Can someone recommend a good above ground pool pump? I don’t want to waste money and want a really good one. I have a 26ft round above ground and...

The original was definately bad, measuring 0 ohms. I replaced it with a Laars kit and hooked everything back up. Still no ignition but the ignitor...