Forum: Pool Equipment & Operations

I just got a 10 year old H200 and I cant get the pilot to light. It seems that the gas flow isnt working properly. My initial thoughts are the gas...

About 1 year ago, my pool service company replaced the original Sta-Rite motor on my circulation pump with an AO Smith Centurion B853 (1HP) (after 3+...

Howdy all... long time no post.. (I have lurked a few times...) I have a Intellitouch computer and the pool temp was displaying very high. ...

We are getting a new liner for our pool, but it has been delayed due to incessant rain. It rains for a few days, then stops for a day or two... then...

I have a Sta-Rite sand filter, when it is set to 'filter' it is also leaking out the waste side. My flat blue waste hose fills up with water. I have...

I have a 25,000 gallon in ground pool and an American Products Titan CM 48 square-foot DE filter. A few years ago I replaced the spider gasket in my...

Hi, I was hosing off my DE filter grids yesterday and I discovered a 1" tear in the fabric of one of them. The unit is old and probably could use...

Would a EC40AC or EC50AC better a better fit for my 24' AG.

I bought a DE filter that was used. It is only 2 seasons old. This is my first with the filter. I just hooked it up and tried it out. My issue i...

Hi all. Last weekend I opened the pool. Unfortunately there was some mud washed in the pool form heavy rain so I started up the filter and pump and...

My Jandy Lite2 heater attempts to stay lit but after initial ignition it shuts off. I am suspecting the flame sensor. (This model was manufactured...

Hello All, I have a Pentair Ultra Flow Pump(8th season) that is leaking back thrpough wher the motor attaches to the pump. It's not leaking at the...

Thanks for all the great info. This WILL be the summer I finally heat my pool. However, I am still on the fence about whether to go with a Heat Pump...

Ok, so I had to swap out my sand filter due to cracking. I filled the new filter with Zeobest like I had in my old one. I initially backwashed...

I cleaned my grid (filter nest) with a power washer and damaged the fabric on some of the flex tubes. I taped the damage with electrical tape, but I...

I would like to change my current filer (cartridge) to a sand filter. I am starting my 4th year with the current cartridges and they need to be...

My pressure is 30psi. i backwash and it goes down but rises very quick. the leaf catcher at the filter only fills half way with water. im new at...

Do I need to use a special breaker when running a line for the pump? The pump will still be plugged into a 110 outlet, but I'm running a line from...

Hi, I have inground pool with sand filter. Problem is that my gouge that shows preassure keeps getting broke. Always the same way - I install new...

Any one have an opinion or personal experience with the Aqua Quik solar heater? Thinking about purchasing but not sure if it's a better purchase...

The guy that installed my 24' AGP setup a block/pole next to the pump that has a switch and 110v outlet with plastic hinge covers that's designed to...

A couple of days ago, the wife plugged in the pump (while I was away) on the new pool we just had installed and the water level wasn't up to the...

I just had a 24' x 52" AGP installed. It was a used pool but looks practically new and the guy that installed did a fantastic job, amazingly level,...

Hey y'all.... tonight, turned on the pool light and it did burn for a bit, then went out. I did check the breaker and it was tripped. Flipped it...

Has any one used any liquid cleaners on their filters and do you suggest them? Also, has any one used any of the water jet cleaners Water-Wand or...

I am considering purchase of a pool heat pump this summer. I understand that as of 12/31/09 USEPA has banned R22 Refrigerant currently used by...

Last night we turned our pump on and it is making this whine type noise. It has been running already this year w/o problems until last night. The...

I just got a NG heater and going to be piping it in. I have had a solar heater for a couple of years so most of the pipe already exists. Now i now...