Pumps, pipes, filters, lights; covers, valves, heaters, coolers; filling and draining . . .
___________________________________ How Much Does Pump Efficiency Matter? ___________________________________ TL;DR: The difference in...
____________________________________ FAQs & Guides: Pool Equipment & Operations ---- June 2018 ---- ____________________________________ ...
I've spent the last three years (yes, that's THREE) rebuilding my existing pool that was originally built in the mid 50's. Lots of problems, lots...
I currently spend a lot on electricity for my pool circulation/filter pump (and, to a lesser extent, for my pool sweep pump). The electric rates...
As a follow-up, I'm down to three choices right now, Hayward, Lochinvar and Sta-rite. Raypak cust service is horrible and my heater croaked after...
I have an concrete IG pool and spa combo, with solar heat that has worked just fine for over a year. With nothing that I've changed suddenly when I...
my dog got mad at me cause i sprayed him with the hose so he took it out on my New Jacuzzi Motor, he pulled on the power wires till the disconnected,...
Just have a question as to how everyones spa spillover works? To me it seems like I have to run the spa jets to get the water to spill over but I...
Does anyone know how to wire a 2 speed pump (Northstar) to Aqualogic controls? The installation instuctions talk about wiring the primary filter...
Current pump just made it through last year. Looking to go from 3/4 HP single speed to 1 HP two-speed. Save some $$ on electricity and get a little...
I need to replace my Purex 2 hp pump (from 1973). The pool is 29000 gallons with a DE filter. I would like to use a WhisperFlo pump, but is not sure...
I have the old Ji-2000 jandy control unit on my pool/spa. It is very archaic and I would like to convert to the PDA. Has anyone done this? I know...
There was a recall on this heater at the CPSC site. For those who might have one. http://www.cpsc.gov/cpscpub/prerel/prhtml07/07073.html Dave
I have a Whisperflo 1.5 hp pump that is about 11 years old. Recently on startup, sometimes it hesitates before starting. I can hear the timer come...
I have an in ground spa attached to our pool and I'm not completely satisified with the amount of flow action into the spa. I have been told if I...
I have a 38x18 pool that was constructed in '56 and I bought the house last year. I have never seen water go into the botton drain, only through the...
I've seen numerous questions regarding lighting so I thought I would throw in a little information. We installed the Fiberstars 6004 fiber optic...
I'd like to have my pool light on a dimmer switch. I believe it's a 500w bulb so getting a dimmer that will handle the load should not be a problem...
I need to pump some water out of my AG pool before it freezes. I had lowered the water level when we closed it at the end of October but then it...
Well it looks like my pool pump died and i dont know where to start so i am in need of help Here is what i have the GIST of it cause i am at work ...
We had a fiberglass pool installed this summer, but our pb hasn't given us any instructions on care so we had a pool service come and "close" it for...
Lately I've been having filter pressures up to 30psi in a matter of days and even after I backwash 2 or 3 times, the pressure doesn't go below 20psi....
I have purchased and installed a Sta-Rite SR200NA natural gas 200K BTU heater. While reading all the fine print I found one place where it says "for...
My cheap pole now turns my hands blue and is chipping, any ideas on a higher quality pole, or what I should look for to avoid this problem in the...
I thank everyone for your responses to my posts below. I have researched flow rates, pumps and volume. Here is what I have come up with: I have...
I am looking into a DE filter for my pool. Right now it has a cartridge filter (70sqft). As I stated in the subject line, my pump just died, and...
I have had a Jandy LAARS LT Pool/Spa heater for about one year, and now the "hi limit" light has come on for the second time. The manual states that...
I was looking for a pump for my pool cover. I was considering this type of pump,...
Has anyone ever had problems getting ladders/rails out? Mine have always been a little difficult. I usually have to bang on the undersides with a 2x8...
I've had earlier questions about operating pressures before (see "Pressure problem"). Now I've noticed when I turned off my skimmer to wait for the...
Bought a blue solar cover today and scissor cut it so that it fits my 20X36 free form in-ground. I had to cut a small section out for the waterfall...
I have been working on our budget lately and realized that I spent over $15,000 on my pool in two years. Some of that was money well spent, but most...
I have an older model Laars Lite 400K BTU propane spa heater that uses a pilot light/flame - rather than electronic ignition. I had my 120 gallon...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules