Forum: Pool Equipment & Operations

Hi, I'm in need of assistance in selecting a new pump to replace my current pump because the motor has a noisy bearing. I have a 20K gal IG Pool...

The pump is old (maybe 18 years), but worked OK last season, and have just started using it again. Now, It will work OK when the skimmer just has a...

Does anyone have a drawing showing the t handle connection to a nautilus two position slide backwash valve? I have a replacement handle, but have no...

Just replaced the 1 hp motor on the Hayward pump system. Also replaced the 120V socket since it was corroded and worn from age. voltage and current...

Just opened up pool today, hooked up filter added more water, turned on filter, added new DE and WHAT???? my psi reading only went to 6,7 not the...

I have looked through a lot of the threads and have come to the conclusion that my issues with my pump and filter are caused by an air leak. The only...

I'm trying to track down a leak that, so far, I can't figure out. The pool is rectangular 13' x 24' concrete that's about 45-50 years old. There is 1...

Trying to figure out dimensions for the pentair superflo impeller locking screw. Product # 355389 please help, driving me nuts not having pool up and...

I searched through several threads but I didn't find the info I needed. I have an AG 15x30 Esther Williams pool and the pump went out. The filter...

We have a cartridge module system that holds 4 cartridge filters. Each filter has a neoprene gasket on the bottom that usually comes out with the...

I'm new so I might as well post my question. I have a Swim Quip light fixture I would like to upgrade to a LED light I was told there are no options...

I have a 24 foot above ground round pool and we found out the filter and other parts are cracked and corroded so we're going to just buy a new pump...

I had a pool pump replaced and the pool company put in a pump that is .5 Horse power less then my old.I am having a hard time getting good enough...

I have an 8 year old Jacuzzi Tri-Clops. We have replaced the original cartridges with some generics. They have been working fine. The problem I'm...

Hello - Asking for some help this year after opening my pool for the past 18yrs. myself w/o a problem. 4 days we opened the pool and the pump...

Hi Gang. Hope everyone's winter is well! I wanted to fix a drip leak I've had in my pump for two years. Not sure of the brand, sticker says...

New to the forum. Trying to see what I can learn on Solar Heaters.

I have a Pentair Amerlite that has a label stating the bulb it came with is a 120V 400W R40. It doesn't have a warning stating that a bulb exceeding...

I have a new solar cover and reel. I know I have to suspend the reel over the middle of the pool but I don't know how to attach the cover to the...

My Lite2 has water damaged circuit boards, I am trying to save it. After putting it back together it did not turn on. The first step according to...

I have a heater that had a copper water line with a pinhole leak recently. A pinhole leak on a pressurized water line turns it into an effective...

My Pentair WhisperFlo 1HP started making some louder then usual noises. So I followed the instructions and took it apart to check for anything...

I would like to put a plan in place so that as my pool equipment either needs to be maintained or replace I can do so in a proper and economical...

Hello folks- I'm on my third pool in ten years having moved a lot. I've picked up some equipment I'm nursing through until I move again and I'm...

I have a dedicated pressure side cleaning line in my pool that we don't use. Will it hurt anything if I open this line for additional circulation in...

This morning I happened to be outside when the pump started and a HUGE amount of air came out of one of the pool jets. It was like a giant "blurp"...

If I am wanting my pool to heat up as fast as possible (save for having a heater), is it best to leave solar cover OFF during the day and cover at...

I have a chance to buy one a a really good price. http://www.amazon.com/MidWest-Canvas-SC-BS-000024-34-Feet-Ground/dp/B004VU8J08 thanks

i have a Hayward in group pump that was humming loudly this year but not kicking on. I took the back off and cleaned up all the contacts nicely...