Forum: Salt Generators (SWCG) & other Chlorine Feeders

I'm trying to decide between the Jandy ei (new system) 35K gallon and the Hayward 40K gallon for my 25K gallon pool in Las Vegas. Because of the...

Does any one have info on the compatibility of salt systems for generating chlorine and their compatibility with stainless steel?

I have 15000 gallon pool with a Aqua Rite Salt Generator wich I replaced a circuit board in in May. When it was added the salt PPM reading on the...

I just bought a house that has an old Autopilot LS1000 system with a RC-15 Cell. The red flow light was on so I pulled the tri-sensor to test it...

I am trying to find the part number from an electrical component next to the SL32 Current Limiter. My circuit board part number is 066012C-1. The...

Just noticed that there is no green power light on my control panel. The display works showing temperature and salt concentration, but there is no...

I have a Goldline SWG and the main board (part number 066012C-1 Rev C) had a bad component on it. It is the large black round resistor? marked SA...

I've had great luck with my Pool Pilot Digital system (10+ years, 2 cells) so I convinced my neighbor to get one when his old Hayward salt unit...

Hi I can not seem to maintain an adequate chlorine level in my salt water pool. I have a brand new in-ground liner pool with a salt water chlorine...

Had a power outage that caused problems with our Aqua Logic PS8. After fixing "Chlorinator Off - No Cell Power" error (required re-soldering a relay...

I'm brand new here so please bear with me. Our Aqualink RS6 completely died this morning. The inside control panel and the outside panel will not...

Hello and thanks in advance for any help. I just installed an Prologic salt system on a vinyl liner pool I built about 6 years ago. I dumped 400...

How many hours a day do you need to run your pump with a salt generator, do you need to turn the water over once or does it have to run 24/7. Thanks

I have a CompuPool CPSC36 operating with my 25,000 inground vinyl pool. It was installed about August 30 of last summer, and we closed the pool in...

I needed to change out a very old Hayward vac. My pump is a itelliflo vf pushing about 32 gal per minute. This keeps operating cost way down. I...

New to the forum and just bought a house that came with a salt water pool. I have a a Zodiac Clearwater Lm2-24 system and it has been nothing but a...

My Aquapure 1400 (4th summer) has service codes 172,181. Cleaned sensors with scrubbie pad and tested board with 1 number different than what they...

Alright, many moons ago, I was a member here -- but I've been inactive for *years*, and am just now re-joining. 'Course, my pool has *also* been...

Hi all. We started using an Intex salt water chlorine generator this year. This model of their generator has a copper ion generator that is used...

I am using an Aquapure 1400 system in my 12,000 gallon plaster pool. I seem to have a significant amount of build-up, (calcium??) in the salt cell....

I have a Pool Pilot Digital running at power level 2 with an SC-36 cell. I replaced the cell at the beginning of this season, as it had gone over...

Hello Everyone, My pool: 15,500 gal, Colored Plaster, Attached Spa, Flagstone (although it's more like Sandstone - more on that maybe in a later...

First off- a few details. IG Gunite Pool Approx. 18,000 gallons. Pentair Whisper-Flo 1-HP single speed pump Pentair Tagelus 60D Sand Filter...

I'd like some advice for setting up a SWCG with a small (10 or 12 foot) above ground pool. I found an Intex 8110 for a good price. Has anyone used...

I'm looking at replacing my QuikChlor system with an Aqua Rite. My pool is apprx 12,800 gals---should I go with the 15k or 25k system? Would going...

Is it safe to use this salt from Lowes in a salt generator-ed pool? ...

I have a four year old Jandy AquaPure 1400. This year I've been getting service lights and error codes referring to low voltage. I've swapped out...

Here's my problem. (I'm writing this on Sunday 8/21/11) Last Wednesday when I got home from work at about 4PM I saw that my pool pump (which is...

Hi, i just had my turbo cell tested at my local pool store and it passed so the cell is in working order. Whe i turn the SWG on, the green power...

How do I know when it's time to replace my salt cell Thanks