Using a Taylor DPD-FAS based testkit? Questions & answers here.
____________________________________________ FAQs & Guides: DPD-FAS based testing ____________________________________________ Guide to...
I did my Baquacil to bleach conversion late last summer and bought Ben's kit. It is great! 2 questions: I have kept it inside. Will it still be...
Hello, i was wondering what are the limits of the new test kit, how high can it test free chlorine levels and cya ect. i looked at the FAQ page but...
Hi, I got Ben's test kit at the end of last season and just started using it. It's all a bit overwhelming at first, but after several uses most...
I am doing an owner-built pool and have just added the water. I have Ben's PS233 test kit. I would appreciate any startup advice you can offer. ...
Beautiful day here so I decided to test my water for the 1st time this season. The pool is still covered. My 1st question is at what temp would...
Here in cleveland we just had our first 70 degree day. I'm looking to replace the broken heater (been broken much longer than I've had the pool) so...
I have the 233 kit. I’m not going to fully open the pool for another 3 weeks or so but the water is starting to get a little over 50 degrees so I...
Well it's that time to open the pool,and took my first reading.Here there are,now I need help with the cya.I have an oval 18x33 AG VINYL liner not...
For the first time since converting from Baq last July, I entered the dreaded pool store for a water analysis. I am out of CYA reagent and with the...
Hey... Appreciate any suggestions on what I should do first...Then 2nd, etc... What should I add? 28,500 16X40 Vinyl IG Pool Water Temp: 80 SWG...
I've seen this question posed before, but didn't read the replies because it didn't interest me at the time..lol. It must have been lost in the...
I have a ps233 that I purchased late in the season last year. I only used it once at the end of September. I wish I had known about the new kit...
26,400 gal Vinyl SG 3100 PPM FC 8 CC .5 TC 8.5 PH 7.5 ALK 130
i was wondering about the correct way to use a test strip, the direction tell you to take a quick reading,how much time to you really have, i notice...
I bought the PS233 kit last fall for my brand new pool that was filled in January this year. The kit works great. I noticed the new PS234 kit will...
Opened pool today, not bad some dust and few leaves on the bottom and oh yes, 1 small dead mole...good thing the wife was out. I'm using the remains...
FedEX Ground guy showed up on Saturday AM with the new PS234 kit!!!! Kind of like a kid at Christmas but its rainning outside :(. Oh well there will...
We just bought a new house with a 23, 000 gallon 10 yr old gunite pool. I just received Ben's new PS234 kit today. Here are the results. Any...
Quick question. I have the 233 test kit. the directions for the Alkalinity test say to add the indicator drops until the liquid turns red. How long...
0 FC 0 TC 7.2 PH 100 ALK 30 CYA 25k gallon ig pool (no liner) I am about to add about 6 gallons of bleach to shock the pool. I was...
I would like to know how long I should wait after adding chemicals (chlorine, CYA, Muratic Acid, etc.) before testing again for those items. I...
I got the message about the new test kit with salt option. This is new to me. Why do I need to test for salt? I do not put salt in the pool. ...
Number are as follows. Any help since this is my first test with this kit???? FC - .5 CC - .5 TC - 1 PH - 7.5
Here's the first run: FC 1 CC 1 TC 2 pH 7.6 Alk 130 Cal 160 Cya 85 Temp 73
Here we go: FC - 7.5 CC - 0 TC - 7.5 pH - 7.3 (it wasn't 7.2 but it wasn't 7.5 either) :rolleyes: Alk - 90 CAL - 40 CYA - 50~60 (The dot got...
Just got my pool cleaned/vac'd yesterday and looking pretty good. I let the pump run all night and just tested my water this morning. The water is...
I just got Ben's kit. This is our first year using chlorine. Could someone please tell me how often to do each test. Also, what numbers am I...
Keep in mind these tests were done before removing the cover. I topped off the pool yesterday (with the winter cover on) & ran the pump & filter all...
I know this is probably the wrong place to post this but I couldnt see where it would fit....any way,,,,I have had the PS233 for a couple years. And...
Hello all, I have a 30' AG pool, and I did my first test of the season. Now, we live in Western NY, so we will not even start opening the pool for...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules