My pump is out of commision.

[Marillionfan]

What would be suggestions for getting bleach into the water till I can find a impeller?

[aylad]

Pour it slowly from a measuring cup while walking around the pool, holding the cup out as far away from the pool sides as you can, then stirring it up with a broom handle or your pole. If it's inground, you can also kind of "toss" it from a measuring cup, a little at a time, toward the center of the pool and especially into the deep end, following it up with a good brushing that will help distribute the bleach, just make sure that you don't splash it onto the side opposite where you're standing.

Janet

[waterbear]

Brushing downs the sides of the pool will set up currents that help 'stir' the water. If you have a wall whale brush it does it even better.

[AnnaK]

Because my pump is on a timer set to come on late at night I nearly always add liquid chlorine while the pump is off. I broadcast it across the water surface using a pitcher and then push the WallWhale across the bottom a few times. A leaf net dragged through the water would have a similar effect.

Sorry to hear about your sick pump!

[Marillionfan]

Not too bad of a problem, of course no one has the part in stock, seems I have an odd pump.
Hopefully in a couple of days I'll be back in business.

Thanks for the info everyone, it was what I was expecting to hear, just nice to know I have back up when needed.

[Marillionfan]

Ended up ordering a new pump.
http://www.poolandspasupplystore.com/servlet/-strse-191/Hayward-Power-Flo-LX/Detail

Mine was 8 years old and the motor didn't want to run the other day until I oiled the bearings and the part would have to be shipped from Canada, so might be better off in the end.