View Full Version : Heater/Raypack 2100 and AutoPilot SWG
slater1182
02-04-2007, 10:28 AM
I have a Raypack heater and would like to install an AutoPilot SWG. As seen in the picture below the Inflow and Out flow seem to be to narrow or close together for the SWG unit.
Will I have any issues installing with this spacing.
many thanks,
http://i170.photobucket.com/albums/u255/slater1182/raypak2100heater.jpg
JoshU
02-04-2007, 01:31 PM
The image isn't showing up for me. After you get it working I would be more than happy to take a look at it for you.
If you're trying to host the image somewhere you may want to try photobucket.com.
Josh
Poolsean
02-05-2007, 12:55 AM
slater,
Not being able to see the photos either, as long as you install the manifold after the heater, you should be fine.
slater1182
02-05-2007, 11:46 PM
got the picture working....thanks!
Poolsean
02-06-2007, 10:28 AM
Got it. Again, plumb the manifold after the heater rather than between the inlet and outlet.
I believe from the heater outlet it goes to a three way valve (if you have a pool/spa combination) or directly to the pool return. If it is a pool/spa combo, them plumb the manifold on the pool return side of the three way valve to avoid overchloriation of the spa.