LOL... now should I be worried??

[Pool_Mike]

:( After reading all these other lesson learned complaints, maybe I should ask and see if I need to be worried.

Right now our pool is getting filled. Last time I checked it is almost full.

-I say tomorrow @ about noon'ish it should be full.

At that point the PB will go dipping and take deep breaths to installed the samLight, cut out all holes for the skimmer, inlet and outlets for the filteration.

The PB said this was the proper way to do it so that they make sure that all air from the back side of the vinyl liner is not there. Weird, but I'll go with it. Should I be concerned ?? :confused:

[Pool_Mike]

double post

[waste]

Mike, it's ok to fill the pool before installing the faceplates and cutting out the liner. In some cases the water has to be up to prevent wrinkles, especially when an inlet/ outlet is located close to a corner that hasn't 'fully seated itself'. Don't worry about it, he's the one getting wet:D. Congrats on the pool being almost finished, with luck you'll be able to enjoy it a couple of times before you have to close it:)

[Pool_Mike]

Thanks, That is exactly what they told me also. :)

I hope to be swimming till mid October :cool:

[waste]

Yeah, we're all in the same union :D
Seriously, they weren't just feeding you BS - Again, happy swimming!!:)