Did I wire this correctly? just changed out my pump....

[supercanadian]

I am replacing my pool pump and just want to be sure I wired this correctly. I think my old pump was 120v and set my new pump to 120 as well. Both say they can be either 220/120.

My old pump is a pentiar superflo.

Here is the old pump with the old wiring setup and the wiring diagram from the pump.

http://i374.photobucket.com/albums/oo181/canuckguy75/photo3_zpscfaa8382.jpg (http://s374.photobucket.com/user/canuckguy75/media/photo3_zpscfaa8382.jpg.html)

http://i374.photobucket.com/albums/oo181/canuckguy75/photo5_zps7bac3ac3.jpg (http://s374.photobucket.com/user/canuckguy75/media/photo5_zps7bac3ac3.jpg.html)

And here is how I wired my new pump a Hayward super pump

http://i374.photobucket.com/albums/oo181/canuckguy75/photo4_zps391de42d.jpg (http://s374.photobucket.com/user/canuckguy75/media/photo4_zps391de42d.jpg.html)

- - - Updated - - -

on my new pump i have the white neutral to L1 and the black hot wire to L2 I assume that is correct....

[supercanadian]

btw i think i figured it out. the bottom picture I set it to 110 not 220. the old pump based on the pictures is set to 220.

[kelemvor]

Maybe test the voltage with a VOM? They can be had for less than $10 (http://www.amazon.com/Digital-VOLT-Meter-Voltmeter-Multimeter/dp/B005EK3NRS/) and are an invaluable tool for any homeowner.

[PoolDoc]

Please tell me that the metal flex I see in the last photo is a TEMPORARY hookup:
http://healthybuildingscience.com/files/2013/01/bx-02cw.jpg
(from http://healthybuildingscience.com)

and that you are going to replace it with some type of LT conduit or UF cable!

[BigDave]

Did you look close at the before picture? I know my electrical inspector would fail the original and the new BX.

[PoolDoc]

Yeah, I saw that. But I figured that's the past. It's the present . . . and that metal flex that worries me.