Medic
05-08-2012, 11:08 AM
My first post has to be here, so please excuse me if this question has been answered before.
I have a Dig 220, just installed the relay as per the instructions. I have triple checked the wire configuration.
My unit still says external timer. I do hear a click when I hit boost, but cannot get my pump to come on. I do see program 1 occasionally in the screen, but cannot get it to program.
How do I get it out of 'external timer' and program mysingle stage pump. BTW, it is set up for 220 and I did check the board to make sure the jumper was in place for 220.
Edited to add.... OK, so I found the answer. The manual says to hold the menu button for 13 (thirteen) seconds, not 1-3. Now if I can just solve my priming problem that just started ... LOL.
This is my second SWG, the first one lasted me almost 8 years and was mostly problem free..
Any thoughts or ideas would be most appreciated.
Thank you in advance for any input.
I have a Dig 220, just installed the relay as per the instructions. I have triple checked the wire configuration.
My unit still says external timer. I do hear a click when I hit boost, but cannot get my pump to come on. I do see program 1 occasionally in the screen, but cannot get it to program.
How do I get it out of 'external timer' and program mysingle stage pump. BTW, it is set up for 220 and I did check the board to make sure the jumper was in place for 220.
Edited to add.... OK, so I found the answer. The manual says to hold the menu button for 13 (thirteen) seconds, not 1-3. Now if I can just solve my priming problem that just started ... LOL.
This is my second SWG, the first one lasted me almost 8 years and was mostly problem free..
Any thoughts or ideas would be most appreciated.
Thank you in advance for any input.