jqgreen
05-29-2011, 10:38 AM
Hi, I have a new intermatic P1353ME timer to replace my old intermatic T104. The pump is wired to terminals 1 and 2 and my heater (a Laars LX400) is wired to terminals 3 and 4.
How does this translate to my new timer?
Thanks!
PoolDoc
05-29-2011, 06:23 PM
Hi;
I'm sorry, but I'm closing this thread. It's not possible to answer your question safely based on the information you've given, but if I don't close the thread, someone may try.
Electrical wiring around pools kills people when it's done wrong, and -- frankly -- your question reveals the fact that you do not know enough to be doing your own wiring, with any reasonable level of safety.
I strongly, VERY strongly, recommend that you hire an electrician. It's a small job, and shouldn't cost too much.
Sincerely,
Ben / PoolDoc