View Full Version : RayPak and Intellitouch i5
dchango
10-09-2010, 09:07 PM
I have an Intellitouch i5 control system. I am trying to connect my RayPak R6350ti-E-HC to the intellitouch, but the manual does not really tell you how. The heat pump has a two wire and three wire remote hook up, I’m not sure where one would attach it to the controller. I contacted Pentair all they would say it is compatible. Any help would be appreciated.
Damon
:confused:
aylad
10-13-2010, 10:33 PM
Bump.....anybody know how to help this poster?
Janet
Pool Clown
10-19-2010, 08:36 PM
http://www.raypak.com/uploads/RP6000.552C.pdf
Page 27 hook up at the heater end.
Calling Raypak may get you a little farther than Pentair for hookup at the Pentair end (go figure).
dchango
10-23-2010, 10:31 AM
Thanks for the info, I have the owners that shows the wire configuration for the RayPak. I did take your advice and contacted RayPak about the hookup, and also sent another email to Pentair. Now its wait and see.
Damon